Laserfiche WebLink
2019 International MV/PL Custom Titan 170 <br />Type I Ambulance Proposal Specification <br />ENTRANCE DOOR POWER DOOR LOCK SWITCHES: <br />The power door lock mechanisms shall be controlled by the OEM door switches <br />REMOTE KEYLESS ENTRY: <br />The power door lock switch located on the drivers' and passengers' side cab doors shall be wired to activate the power <br />lock/unlock function of the ambulance body entrance doors (and compartment doors when power feature is specified). <br />The switch shall be tied to the battery side of the master disconnect switch and function whenever depressed. <br />In addition to the cab door control of the power door locks, a remote keyless entry system shall be installed. The system <br />shall lock and unlock the cab and ambulance doors as specified above. The vehicle shall be delivered with two remote <br />keyless entry devices and programmed to operate with the vehicle. The remote device shall be capable of being attached <br />to the key ring of the vehicle. <br />SIDE ENTRANCE DOOR <br />POWER DOOR LOCK SWITCH: <br />A double throw momentary switch shall be provided inside the side door area near the load light cancel switch - above the <br />fluorescent light timer, for activating the power lock/unlock function of the ambulance body entrance doors (and <br />compartment doors when power feature is specified). Press up for lock, push down for unlock. <br />REAR ENTRANCE DOOR <br />'70WER DOOR LOCK SWITCH: <br />A double throw momentary switch shall be provided on the left side near the load light cancel switch for activating the <br />power lock/unlock function of the ambulance body entrance doors (and compartment doors when power feature is <br />specified). Press up for lock, push down for unlock. <br />POWER DOOR LOCKS OVERRIDE SWITCH: <br />A concealed emergency override switch shall be provided and located as specified below-, <br />- Front Driver Side Grille Area <br />EMERGENCY WARNING SYSTEMS <br />HEADLIGHT WARNING SYSTEM <br />HEADLIGHT FLASHER: <br />A Sound Off, Inc., headlight flasher shall be installed to alternately flash the vehicles high beam lights. The unit shall be <br />hermetically sealed solid state unit controlled by a single pole lighted switch in the driver's console. The circuit shall be <br />relay controlled. The unit shall be installed per manufacturer's recommendations and shall not affect the vehicles lighting <br />system. The unit shall be disabled when the headlight switch is on. <br />A Sound Off, Inc., headlight flasher shall be set to the "ETM", 215 FPM, <br />A4539-0001 08/24118 <br />35 <br />