Laserfiche WebLink
2019 International MV/PL Custom Titan 170 <br />Type I Ambulance Proposal Specification <br />UNISTRUIT SHELVING STANDARDS, INTERIOR <br />CABINET SHELVES: <br />The interior cabinets of the vehicle shall be provided with Unistrut shelving standards. The standards shall be aluminum <br />with the approximate dimensions of 3/8" by 1" wide. The Unistrut shall be securely fastened to the interior of the cabinets <br />with #10 threaded fasteners. <br />INTERIOR ENTRANCE DOORS <br />All entrance door panels shall be mounted with machine screw threaded fasteners which are installed with thread looking, <br />Loc-Tite material. <br />INTERIOR ENTRANCE DOOR PANELS: <br />The inside surface of the right side and rear entrance doors shall have three (3) sections. The upper shall be an aluminum <br />panel covered with high pressure plastic laminates which matches the interior cabinets. The center area which covers the <br />door hardware shall be a padded vinyl section and the lower panel shall be a single piece of polished aluminum diamond <br />plate, to act as a wear surface. The panels shall be held in place with threaded mechanical fasteners and be removable <br />for servicing of door hardware. <br />ABOVE DOOR HEAD BUMPERS <br />SIDE ENTRANCE DOOR HEAD BUMPER: <br />..�cushioned, matching vinyl covered "bump protection" head bumper shall be mounted in the interior of the side entrance <br />door area, It shall be designed to provide both onward and upward contact protection <br />REAR ENTRANCE DOOR HEAD BUMPER: <br />A cushioned, matching vinyl covered "bump protection" head bumper shall be mounted in the interior above the Rear <br />entrance doors. It shall be designed to provide both onward and upward contact protection <br />INTERIOR GRAB RAILS <br />GRAB RAIL RETENTION: <br />All ceiling grab rails installed in the ambulance shall meet the requirements of the A.M.D grab rail retention test. Test <br />documentation shall be provided upon request. <br />72" CEILING GRAB RAIL, OVER SQUAD BENCH: <br />A satin finish stainless steel grab rail shall be installed in the ceiling over the squad bench. It shall be 72" long x 1 1/4" in <br />diameter with welded stanchions every 24". It shall have fully radiused ends to eliminate a head injury hazard. The use of <br />grab rails which do not have fully welded construction is unacceptable. The grab rail shall be bolted directly to the <br />structure members of the ceiling framework. <br />A4539-0001 <br />08/24/18 <br />24 <br />