Laserfiche WebLink
2019 International MV/PL Custom Titan 170 <br />Type I Ambulance Proposal Specification <br />(1) in right lower corner of the "C" compartment <br />(1) in the left lower corner of the "C" compartment <br />REAR STEP BUMPER: <br />A full length reinforced rear bumper shall be installed on the rear of vehicle. The bumper shall be fabricated from 3" <br />aluminum 6061-T6 structural channel and securely bolted to the vehicle frame using high strength, grade 8, 1/2" bolts. <br />The bumper shall have contoured ends and be covered with polished aluminum diamond plate end caps. in addition, two <br />full end gussets shall be provided to support the bumper ends in the event of minor impact. The gussets shall be <br />fabricated from 3" x 2" x 1/4" structural aluminum tube 6061-T6. No exceptions to size of gussets. <br />The bumper shall incorporate a design that allows it to be recessed under the rear of the body. Any rear bumper design <br />that does not have a recessed design shall be unacceptable. The under body recessed bumper design allows the chassis <br />frame to absorb minor impact without any damage to ambulance body. <br />LIFT -UP REAR STEP; <br />RECESSED STEP RISER: <br />The rear step bumper shall incorporate a 44" long by 9 1/2" deep, lift -up center section made of extruded aluminum, <br />"Diamond Back" safety grating. The step shall hinge on a full length stainless steel piano hinge. Note: When the step is in <br />the load position the step shall be totally within the exterior of the body and shall not protrude beyond the door sill. <br />DOCK BUMPERS: <br />"mo (2) Heavy duty black rubber dock bumpers shall be installed on the rear bumper ends, (1) each side. The bumpers <br />.hall be 2" high, 10" long and protrude 2" outward from rear bumper. The dock bumpers shall be bolted to the structural <br />channel of the rear step bumper. <br />ALUMINUM DIAMOND PLATE ACCESSORIES <br />FRONT STONE GUARDS: <br />High polished . 100 aluminum diamond plate stone guards shall be installed on the front body corners. The guards shall be <br />one piece & contoured to fit the 1 5/8" outside radius of the body. The stone guards shall be removable for repair in event <br />of damage. The edges of the diamond plate panels shall be sealed with a closed cell gasket around the perimeter, to <br />prevent moisture from getting behind panels. All panels shall be removal if required. <br />RUB RAILS, "C" CHANNEL: <br />"C" Shaped rub rails shall be installed on the lower body skirt panels under the door line with open Flanges pointing away <br />from the body. The rub rails shall be Custom Aluminum Channel. The ends shall be charnfered and all sharp edges <br />sanded. The aluminum shall be protected with an anodized Bright -Dip finish. The rub rails shall be attached to the body <br />with .625 deep rubber spacers that hold the channel off the body. This spaced design prevents debris from accumulating <br />between the Rub Rails and the painted body. Designs that are not offset from the body are unacceptable due to their <br />tendency to accumulate debris. The rub rails shall span the left and right side of the ambulance body on either side of the <br />rear wheel opening. <br />A4539-0001 <br />08124/18 <br />13 <br />