Opening of Quotations - Beck's Lake Overflow Valve Materials Procurement - Ferguson Waterworks

Home Browse Search

applications to the specified service. 3. When not applied by the manufacturer, lining and coating Subcontractor shall have a minimum of five years successful experience in the application of the specified linings and coatings for similar applications for the specified service, and shall be able to show evidence of at least five installations in satisfactory operation in the United States. D. Supply and Compatibility 1. Unless otherwise approved, obtain all pipe, fittings, and appurtenances included in this Section from a single ductile iron pipe manufacturer. 2. Ductile iron pipe manufacturer shall review and approve all Shop Drawings and other submittals for pipe, fittings, and appurtenances furnished under this Section. 3. Pipe, fittings, and appurtenances shall be suitable for the specified service and shall be integrated into overall piping system by ductile iron pipe manufacturer. 4. Ductile iron pipe manufacturer shall be responsible for all products and all factory -applied linings and coatings, whether installed at pipe manufacturer's facility or at manufacturer's Supplier's facility. E. Regulatory Requirements: 1. Pipe and fittings, including linings and coatings, that will convey potable water or water that will be treated to become potable, shall be certified by an accredited organization in accordance with NSF/ANSI 61 as being suitable for contact with potable water, and shall comply with requirements of authorities having jurisdiction at Site. 1.5 PRODUCT DELIVERY STORAGE AND HANDLING A. Supplier shall coordinate delivery of the product to the City of South Bend with the City's Project Representative at the Wastewater Treatment Plant. B. Materials shall be delivered and inspected at the Wastewater Treatment Plant located at 3113 Riverside Drive, South Bend, Indiana, 46628. C. Deliveries shall be scheduled between the hours of 8:00 A.M. — 2:00 P.M., Monday through Friday. No deliveries will be accepted on weekends or City recognized holidays. PART 2 — PRODUCTS 2.1 PERFORMANCE CRITERIA A. Products provided shall meet or exceed the minimum requirements of this specifications. 2.2 MATERIALS A. Ductile Iron Pipe — Wall Sleeve (Flanged End — Plain End) 1. Ductile iron pipe materials shall be domestic for this procurement contract. 2. Wall sleeve shall be a Plain end — Flanged End configuration. 3. Flanged pipe shall be fabricated in accordance with ANSI/AWWA C115. 4. Non -Flanged pipe shall conform to ANSI/AWWA C151 for material, pressure, dimensions, tolerances, tests, markings, and other requirements. 5. Wall sleeve shall be 30" diameter. 6. Wall sleeve width shall be 12" end -to -end dimension. 7. Wall sleeve flange shall be drilled and tapped with holes to mate with the specified Flanged Check Valve. Coordinate bolting pattern with Flanged Check Valve manufacturer prior to fabrication. Mating flange shall be flat and full-faced. 8. Wall sleeve flange mating surface shall be serrated to grip the rubber flange of the Flanged Check Valve specified. The serrations should be cut 1/16-inch deep, with 90° angle tool point. The pitch should be 8 (eight) cuts per inch. 9. Mating Flange inside diameter must match the Flanged Check Valve sleeve inside diameter. 10. Products and Manufacturers a. McWane Ductile b. American Cast Iron Pipe Co. c. U.S. Pipe Fabrication d. Or equal. 11. Pipe Joints: Version 10/18/2016 Page - 7 Public Works Quote