Laserfiche WebLink
TYPE DESCRIPTION <br />Safety: Truck and equipment to conform to All State and Federal <br />occupational health and safety requirements, including back up <br />warning device. <br />Lighting: Lights and reflectors: All lights shall meet federal requirement <br />FMVSS No.108. All body wiring shall be in a complete pre built <br />sealed factory wiring harness. Harness shall be fully wrapped to <br />prevent damage and shall require only three leads to tie into chassis <br />lighting system a simple wire loom will not be accepted. Body <br />builder shall provide a complete wiring schematic all acid on fight <br />wires upon delivery. <br />Cab Shield -The emergency cab shield lighting shall have sic (6) oval light <br />Lighting: holes laser cut at the body manufacture facing forward and 6 facing <br />rearward. Six LED amber strobes shall be on the front of the cab <br />shield facing forward, two LED amber strobes shall be on the sides <br />of the cab shield facing sideways, and Six LED amber strobes shall <br />be on the back side of the cab shield bulkhead facing rearward. <br />=There shall be a set (one per side) of LED amber strobe lights <br />mounted on the body lower rub rail midway between the front and <br />rear of the dump bed. <br />There shall be a LED sander light installed at the rear of the body <br />location shall be determined by purchaser. <br />-There shall be two LED underbody lights mounted on the each side <br />of the unit to allow the operator- to see the underbody during <br />nighttime usage. <br />-Body shall be equipped with all -necessary lights and reflectors to <br />meet state and ICC specifications. Lights shall be installed in rear <br />corner post of body using 3 oblong type lights (body is not to be <br />widening for lights). Top lights one per side shall be LED strobe, <br />2W shall be LED stop tail turn and 3rd from top shall be LED <br />combination stop /tail / reverse. <br />-All add on lights shall be LED no exceptions due to safety <br />concerns. <br />-All lights shall be tied to the chassis switch pack in a configuration <br />18 <br />SHALL BE <br />AS <br />SPECIFIED <br />(Circle One) <br />YES NO <br />(SD <br />NO <br />