Laserfiche WebLink
H. Quantity of two (2) water cooled MIG welding torches <br />X Quantity of one (1) robot software including speed check, 1/0 connect, and 4D graphics <br />A. Quantity of one (1) through arc weld seam tracking for both arms <br />K. Quantity of one (1) touch sensing <br />A. Quantity of one (1) multi -equipment feature to configure controller to control multiple <br />welding power supplies <br />/M. Quantity of one (1) software to allow multiple arms to work in coordinated fashion with <br />servo controlled part positioning devices and/or servo controlled robot transport units <br />A. Quantity of (1) single zone robotic work cell with 360 inch span and floor mounted control <br />stand, 15 meter safety light curtain protected work zone entry points for RIA 15.06 <br />compliance, light tower with status indicators for work zone safe/ready, work zone <br />unsafe/operational, restricted space compromised and system fault. Pneumatic arc <br />protection panels between the robot positioners to minimize cross -station arc flash. <br />Forklift portable common base platform for robot, robot controller, welding power supply, <br />cable trays and fence enclosure with access door. <br />V✓/O. Quantity of two (2) welding shield gas regulators <br />/P. Quantity of one (1) reaming station with 5/8 inch reamer bit, antispatter fluid spray unit, <br />/ pneumatic wire clipper and anti -spatter fluid <br />Q. Quantity of four (4) Keyence area safety laser scanner <br />✓R. <br />�� <br />4 <br />Quantity of one (1) system positioner with brake, straight shaft, and key way <br />Quantity of one (1) turning roll tool with fixed ball transfer end stop to allow rotation and <br />ID weld access, pneumatically actuated hold down clamps with change out tip and <br />grounding station, pressure controlled pneumatic cylinder with ball transfer to allow <br />rotation, angular compliance and ID weld access, pneumatic cylinder to extend and <br />retract timing feature, turning roll idler with manually adjusted positioning and 5,000 <br />pounds capacity, turning roll driver with manually adjusted positioning and weight <br />capacity 5,000 pounds and turning capacity 10,000 pounds <br />Quantity of two -thousand (2000) pounds of 0.045 inch welding wire <br />U. Dual 100 amp power disconnect panel capable of supplying 480 volt, 3-phase, 100 amp <br />power to 2 robots and 2 welding power sources <br />A. Run-off requirement quantity of five (5) sample parts including the following Nello <br />Corporation item numbers: <br />i. 129729 <br />ii. 129755 <br />iii. 131063 <br />iv. 131217 <br />V. 131394 <br />1 J ✓ W. Delivery freight to be included in the proposal <br />