Laserfiche WebLink
PAGE 6 of 6 <br />PRODUCT SPECIFICATION <br />© OTTO ENVIRONMENTAL SYSTEMS NORTH AMERICA, INC. <br />Durability During Pulling Test ANSI Z245.30-2008 <br />The following Quality Assurance tests are performed according to ASTM procedures. <br />Material Testing <br />1.Melt Flow Index Test: To check that the polymer batch matches the supplier <br />certification. This is testing procedure ASTM D1238. <br />2. Colorant Color Match: Compare lot based color chips to the color chip master to <br />ensure consistency. <br />In-Process Quality Tests <br />1.Drop Test: Cart is raised 12' under load and dropped 4 consecutive times. This <br />provides that there is not a processing issue. <br />2. Bib Pull Test: Bib pulled to failure to evaluate brittleness. Bib should break <br />tensile. <br />3. Bar Pull Test: Bar pulled to failure. Determines if there is weakness at knit line at <br />center of plastic bar. Bar should break off center. <br />4. Fit Checks: Mating components (axle, lift bar, lid) installed onto carts after cooled <br />to ensure proper fit, form & function. <br />5. Weight & Thickness Checks: Evaluates molding process. <br />All designs, specifications, and components are subject to change at the manufacturer's <br />sole discretion at any time without notice. Data published herein is informational in <br />nature and shall not be construed to warranty suitability of the unit for any particular <br />purpose as performance may vary with the conditions encountered.