|
AGRICULTURAL USE REQUIREMENTS
<br />Use this product only in accordance with its labeling and with the Worker Protection Standard, 40 CFR Part 170. This standard contains
<br />requirements for the protection of agricultural workers on farms, forests, nurseries, and greenhouses, and handlers of agricultural pesticides.
<br />It contains requirements for training, decontamination, notification, and emergency assistance. It also contains specific instructions and
<br />exceptions pertaining to the statements on this label about personal protective equipment (PPE), notification to workers, and restricted -
<br />entry interval. The requirements in this box apply to uses of this product that are covered by the Worker Protection Standard.
<br />Do not enter or allow worker entry into treated areas during the restricted entry interval (REI) of 12 hours.
<br />Ex
<br />f11pfign; If the product is applied by drenching, the Worker Protection Standard, under certain circumstances, allows workers to enter
<br />the treated area if there will be no contact with anything that has been treated.
<br />PPE required for early entry to treated areas that is permitted under the Worker Protection Standard and that involves contact with
<br />anything that has been treated, such as plants, soil, or water, is:
<br />• Coveralls over long-sleeved shirt and long pants,
<br />• Chemical -resistant gloves made of any waterproof material,
<br />• Chemical -resistant footwear plus socks,
<br />• Chemical -resistant headgear for overhead exposures
<br />NON-AGRICULTURAL USE REQUIREMENTS
<br />The requirements in this box apply to uses of this product that are not within the scope of the Worker Protection Standard for agricultural
<br />pesticides [40 CFR Part 170]. The WPS applies when this product is used to produce agricultural plants on farms, forests, nurseries, or
<br />greenhouses.
<br />Do not enter or allow others to enter the treated areas without protective clothing until spray has dried.
<br />COMMERCIAL TURF AND ORNAMENTALS
<br />PRODUCT INFORMATION
<br />This product is formulated as a flowable liquid. It contains the active ingredient thiophanate-methyl, a broad spectrum fungicide which
<br />exhibits preventative, curative and systemic properties. It is useful on a wide variety of turf and ornamental disease problems. Apply with
<br />ground equipment using sufficient spray volume to provide thorough coverage.
<br />Resistance Management: To avoid the development of tolerant strains of fungi, this product should be used with fungicides of different
<br />modes of action. Using this product in combination or rotation with products containing active ingredients that have similar chemistry and
<br />mode of action, such as thiabendazole, may contribute to development of disease tolerance. If, after using this product as specified in
<br />this label, treatments are ineffective, a tolerant strain of fungi may be present. Consult your local Harrell's, LLC representative, your State
<br />Agricultural Experiment Station, or your State Cooperative Extension Service for proper disease identification and advice on the prompt use
<br />of some other suitable fungicide or disease control strategy. As long as specified precautions are followed, this product can remain useful
<br />for disease control.
<br />Mixing Instructions: SHAKE WELL BEFORE USING. Some settling may occur during prolonged periods of non-use. High pH environments
<br />can cause thiophanate-methyl, the active ingredient in this product, to break down and result in loss of efficacy. Buffer the tank water to pH
<br />6-7 before adding this product for optimum product performance. Add required amount of product to partially filled tank (1/2 total volume),
<br />agitate by mechanical or hydraulic means, add tank mix product if used. Do not tank mix this product with copper -containing materials
<br />or with highly alkaline pesticides, such as Bordeaux mixture orlime sulfur (for more information, see `Tank Mixing Instructions" below).
<br />Agitate again and then add remaining required amount of water. Maintain continuous agitation in the spray tank to keep the material in
<br />proper suspension. For best results, use spray mixture the same day it is prepared.
<br />Tank Mixing Instructions: It is the pesticide user's responsibility to ensure that all products included in the tank mix are registered for the
<br />intended use. Read and follow the applicable restrictions and limitations and directions for use on all product labels involved in tank mixing.
<br />Users must follow the most restrictive directions for use and precautionary statements of each product in the tank mixture.
<br />This product is compatible with most commonly used pesticides. If tank mixing with other materials, add products in the following order:
<br />water soluble bags, wettable powders, dry flowables, liquid flowables, emulsifiable concentrates, and soluble materials such as fertilizers.
<br />No claim of compatibility with other products is implied. Do not tank mix with copper -containing materials or with highly alkaline
<br />pesticides, such as Bordeauxmixture orlime sulfur. This product may be applied in conjunction with chemically neutral liquid fertilizers.
<br />Avoid application in conjunction with highly alkaline fertilizers, such as aqueous ammonia, as they may cause degradation of the pesticide,
<br />resulting in reduced performance.
<br />
|