Laserfiche WebLink
i II! led in l.')y W A,Iaries <br />TYPE DESCRIPTION <br />Driveline: The hydraulic pump shall be driven directly off the engine crankshaft via <br />a splined driveline to allow for movement. The driveline shall include <br />grease fittings on both u-joints. Spicer model 1350 series or equal. <br />Reservoir: The hydraulic reservoir will have a minimum capacity of 35 gallons and <br />be mounted on the chassis frame between the body and the chassis. The <br />hydraulic tank shall be a minimum of 7 gauge and be powder coated. The <br />reservoir will include a sight/temp gauge, a suction strainer and a <br />magnetic drain plug. The reservoir top will include a 90-gpm-cartridge <br />style return filter with 10-micron element and 25 psi bypass. One spare <br />element to be furnished with the truck at the time of delivery. <br />Reservoir shall have a float assembly wired to the console to notify the <br />operator of a low oil condition. <br />Initial fill of AW-32 oil shall include antifoam and anti -wear package. <br />The tank shall require no more than 13 inches in width and shall not <br />prevent the body from sitting a maximum of 16" from the back of the <br />chassis cab. If truck has CNG engine package than tank will need to be <br />frame rail mounted. <br />There shall be a clean out hole 7" x 6" located in bottom of hydraulic tank. <br />Hydraulic tank shall have shut off to allow service without draining <br />hydraulic tank. <br />Hydraulic Valve: The hydraulic valve will be a cast iron, sectional type <br />spool valve. Valve will feature individual section and flow <br />compensation for each section. The valve will be rated for a nominal <br />flow of 30 gpm. The load sensing shuttle network will be accessible <br />without valve disassembly. <br />Sections will be provided for following: <br />Dump hoist: double acting with down relief <br />Scraper: Dual Axis up- down right —left <br />Front plow double acting with reliefs <br />Front plow angle with reliefs. <br />Valve Enclosure: The hydraulic valve will be mounted in a sealed <br />enclosure. The enclosure will feature an automotive type bulb seal and a <br />bolt on lid. Enclosure will be constructed of 304 stainless steel and be 7 <br />gauge in thickness. The hydraulic valve will mount inside and be <br />plumbed to the enclosure with steel tubing. Connections on the front of <br />18 <br />SHALL BE <br />AS <br />(Circle One) <br />V S ))NO <br />'AYES NO <br />