Laserfiche WebLink
Y /N <br />11.3 RADIO CUTOUT <br />A cutout for installation of a radio shall be provided in the forward section of the <br />overhead squad bench cabinet. A 114" black Kydex cover shall also be provided. <br />Y N <br />11 A SPEAKER SYSTEM <br />Two (2) speakers shall be provided and mounted in the rear module ceiling. They <br />shall be connected to the cab AM/FM radio. A separate volume control and fader <br />shall be provided in the rear action area. <br />Y �N <br />11.5 ACTION AREA OVERHEAD CABINET <br />A cabinet shall be installed above the action area and shall be provided with one (1) <br />adjustable shelf. <br />11.5.1 It shall have "restocking type" Plexiglas doors. The doors shall slide, than flip - <br />up for easy, full width access. <br />Y /N <br />11.5.2 A full length, aluminum handle shall be provided on each door. �___. <br />Y3ZN_ <br />11.6 WRITING DRAWER BELOW ACTION AREA <br />A writing drawer shall be provided below the action area, in the rearward position. It <br />shall have approximate dimensions of 2 314" high x 14" wide x 15" deep. It shall <br />have a Plexiglas writing surface with flush mounted hinges at the rearward section, <br />so that when the tray is full extended, the writing surface can be lifted to allow easy <br />access to a storage area below. In the closed position, it shall be flush with the front <br />edge of the cabinetry. The storage area shall be large enough to hold writing <br />instruments, a bound notebook, calculator or small miscellaneous items. <br />113 CABINET BELOW ACTION AREA <br />A storage cabinet shall be provided below the 1st action area, in the forward position. <br />This cabinet shall be made of the same materials as the rest of the cabinets. This <br />cabinet is designed for inverter, miscellaneous or radio module storage. <br />Y_ZN_ <br />11.7.1 It shall have sliding Plexiglas doors. <br />Y VN <br />11.7.2 A full length, aluminum handle shall be provided on each door. <br />YjeLJN,_,_ <br />11,8 LOWER STREETSIDE CABINET <br />A cabinet approximately 16" wide x 12" high and full depth shall be provided under <br />the 2nd action area. <br />Y �N <br />11.8.1 It shall have tilt -out door. <br />YVN <br />11.8.2 A round stainless steel SouthCo latch (or equal) shall be provided on the <br />door. <br />50 <br />