Laserfiche WebLink
Hydraulic Lines All hydraulic lines, pipes, hoses, and fittings shall be of <br />& Plumbing: sufficient capacity to accommodate the volume of oil <br />without undue heating or turbulence in the system. A 2" <br />suction line with a minimum SAE rating of 100-R4 must be <br />used between the reservoir and the inlet of the pump. This <br />suction hose shall be secured on both ends via heavy duty <br />banding straps, radiator hose clamps -unacceptable. All of <br />the pressure hoses, including the signal sensing line to the <br />pump must have swivel fittings on BOTH ends and have a <br />minimum SAE rating of 100-R2. Return lines and the case <br />drain line must have a minimum SAE rating of 100-RI. <br />All fittings shall be JIC. Push on clamp fittings are not <br />acceptable. <br />Hydraulic lines shall be routed to minimize interference <br />with equipment and chassis components requiring periodic <br />servicing. Appropriate support brackets, grommets, and tie <br />wraps shall be provided to protect lines from abrasion, <br />cutting and impact damage. Hoses shall not be installed <br />near manifold or exhaust pipes so as to be affected by <br />extreme heat. There shall be no pipe fitting used with any <br />high pressure lines. Any and all hydraulic quick disconnect <br />couplings used for spreader system and snow plow <br />reversing system shall be of the bulkhead mounted style <br />and be rigidly attached without the use of any hose clamp <br />arrangements (loose hose ends are NOT acceptable), Couplers to <br />be mounted to side of dump bed so they do not get covered with <br />material or broken. Dust cap for male ends and dust plug for <br />female ends must be attached to couplers. Maximum distance <br />allowed between support clamps on all hydraulic hoses shall be <br />approximately 24". <br />Electronic The spreader control will utilize PWM technology to <br />Manual control the variable feed and spread widths. The feed rate <br />Spreader knob will accommodate 9 different settings while the <br />Control: spread width knob will also accommodate 9 settings. The <br />control head will have a power switch with an indicator <br />lamp to provide status on the operation of the controller. Unit to be <br />mounted for safe use by driver. <br />Controller shall be Storm Guard Freedorn 2 controller. <br />Spreader control shall have ability to be touch screen with usb data <br />download. <br />TEP wiring harness. <br />Screw on cap and plug set for motor sensor connection. <br />Detailed operators manual, <br />19 <br />YES )NO <br />YES')NO <br />