Laserfiche WebLink
Shall have a mil <br />one in center, of <br />(minimum). He <br />wire minimum) <br />factory on box. <br />frame. LED lip <br />Electrical: <br />Rear Pintle <br />Hitch: <br />Capacity: <br />Note: <br />Mounting of DuMP-B-,dy <br />nu-n of three (3) brackets (each side) - 2"x 4" flat iron minimum, at least one at rear, <br />at front. Shall be welded at rear and bolted with three (3) 5/8" bolts per bracket <br />t cylinder shall be hooked to central hydraulics with 3/4" high pressure hose (two <br />Floor of body to be approximately 54" off ground +/- 2". All welding to be done at <br />Cher welding to be certified. Two rear hooks shall be supplied and bolted to rear of <br />All lighting shall be LED. <br />YES NO <br />The wiring junction box is to be located on the right side of <br />the body a minimum of 58" off the floor. The electrical <br />box is to be completely sealed and waterproof. All wiring <br />to be continuous (without splices) and run inside of a <br />waterproof harness. All connections are to be made inside <br />waterproof junction boxes or within the structure of the <br />body. Warning lights, strobes, and plow lights each to be <br />run off OEM switches. Also included will be a pair of <br />Truck Lite LED Model #80880 or equal plow lights mounted to <br />stainless steel brackets on hood. Plow lights to LED and integral to <br />OEM headlights. Sealed lighting system shall be installed <br />consisting of four (4) nylon tail/brake lights, two (2) on each side, <br />and two (2) Whelen amber nylon alternating strobe flashing lights, <br />one (1) on each side, mounted at top and two backup lights, one per <br />side. The sealed lighting system shall be boxed into the rear corner <br />posts, not to exceed a total box width of 99". All light wiring shall <br />be in sealed tubing. All lights shall be standard 3 phi plug in style. <br />There shall be a set of LED amber strobe lights mounted in weather <br />protected boxes mounted under the cab shield facing forward. <br />There shall be a second set of LED strobes mounted under the. cab <br />shield facing on both sides of body. Fights shall be installed in <br />approved manor by the City. There shall also be an underbody <br />plow light that will direct light on the underbody plow and a <br />spreader light positioned at the left rear lower corner of the bed. <br />Wallace Forge 2044101, 50,000 lb or equal, mounted rear of truck, <br />S NO <br />center of hitch 25 1 /2" from ground and center of truck. <br />5,000 lbs. maximum vertical load <br />6)INO <br />50,000 lbs. maximum gross trailer load <br />Drawbar eye dimensions. 2" to 3" 1D 1 1/4" to 1 5/8" diameter <br />section. <br />Central Services on exact location of hitch <br />(Y)ES/ NO <br />Vendor will check with <br />and exact location of all rear mounted lights. <br />17 <br />