Laserfiche WebLink
F�Ued ni by VV A SHALL BE <br />AS <br />TYPE DESCRIPTION SPECIFIED, <br />(Circle One) <br />Specifications for 14' Stainless Steel Multi -Use Dump Body <br />The intent of these specifications is to obtain a dump body which meets the highest standards of the <br />industry with respect to quality and strength of materials, design and workmanship to the finished <br />product. The successful bidder shall be responsible for all warranty repairs. <br />Multi -Use The dump body should have a telescope hoist and an integral ("'VEPS / NO <br />Heavy Duty discharge system built into the floor capable of conveying or <br />Dump Body: spreading a variety of materials. The overall length shall be 14'. It <br />shall have a capacity of 12 to 14 cubic yards without side boards. <br />Body construction shall be seven gauge 201 #4 stainless steel <br />construction, minimum throughout (no exceptions to grade and or <br />type of steel will be accepted). Body shall have boxed top rails, full <br />depth rear corner posts and bolster. Body shall have a maximum of <br />a 2 inch side to floor radius (welded inserts are not acceptable). <br />Remote grease extension manifold for all body grease points <br />The bottom of the sides will have a 30 degree sloped rub rail that is <br />5" wide. Continuous weld throughout. There shall be a 3" C <br />channel welded to the bottom longitudinal to form a base that will <br />rest on truck chassis. <br />Shovel Holders; Body shall include two spring mounted shovel <br />holders located on the driver's side front body bulkhead. <br />Vibrator: There shall be a vibrator mounted to the underside of the <br />dump body. Vibrator should include mounting plate and safety <br />chain. <br />Reflective Tape: There shall be a 2" reflective tape installed both <br />bottom sides and at the rear of the dump body. Tailgate shall have <br />2" reflective tape installed around the perimeter facing to the rear. <br />Spread Apron shall be three piece with the center removable and <br />shall bolt on. Apron shall be hinged so that when pulling out of <br />spreader it will slide upwards. Spreader apron shall extend 12" <br />and shall be constructed of 7 gauge 201 44stainless steel. <br />it <br />