Laserfiche WebLink
RQUIld pole <br />"2, 4, 5, <br />8,9 <br />14 <br />4, 5, <br />Pre -Installation when universal mounting bracket adapter is ordered as an accessory: <br />SQUARE POLE INSTRUCTIONS. p a) ROUND POLE INSTRUCTIONS: a) <br />Discard the following parts when received : Discardthefollowingpartswhenreceived b) <br />with the fixture: with the fixture: ® • <br />., 0 s c) <br />a) Red <br />gwitat bar stock ingbloth the <br />krises 0 s) 3-1/2'fletbarstockwiththe3holes • a <br />Ill Red bag with mounting block assembly � �6a b) RPA-round pole adapter Q <br />and the 2-2" bolts and washers lD� b) c) Red bag with mounting block assembly <br />and the 2-2' bolts and washers <br />Installation of the universal mounting bracket adapter (reference previous page for parts list): <br />1.Loosen the 4-3/8'diameter byt-1/4"stainless steel hex socket head screws (1) an the top and bottom of the universal adapter cover plate assembly. Remove <br />the universal pole adapter(3). <br />2. Remove the universal pole backing assembly (7) from the universal pole adapter (3) by loosening and removing the both of the 1-1/4' bolt/washer assemblies <br />(GA, 6B, 6C). Set aside for reinstallation. <br />3. Slide on boll/washer assembly (6A, 6B, 6C) through the slat of the universal pole adapter (3) as shown in diagram above making sure the adjustable slide <br />is accessible to slide it up or down in order to line up with the bottom hole of the current drilling of the pole. <br />4. Place the universal pole backing assembly (7) inside the pole aligning itwith the drill pattern on the pale. <br />5. Place the universal pole adapter (3) with the first bolt/washer assembly (6A, 66, 6C) combined (from step 3) on the outside ofthe pole (narrow portion of the <br />adapter facing upwards). Thread the bolt/washerassembly through the fop hole of pale end into the top threaded hole of the universal pole backing assembly 17), <br />6. Position the slide on the universal pole backing assembly (7) in alignmentwith the bottom hole in the pole. <br />7. Slide the second bolt assembly through the universal pole adapter's slat (3), through the bottom hole of pole and screw into the threaded hole of the slide <br />on the universal pole backing assembly (7). <br />8. Check plumb and level of the universal pole adapter (3) and secure bolts tightly. <br />S. Place the cover plate assembly (2), narrow portion of the plate facing upwards, over the universal pole adapter (3). <br />10. Retighten screws (1) on the top and bottom of the universal adapter cover plate assembly until adapter is secure to the pole. <br />11. Proceed to follow directions for fixture installation. <br />Part Number: RJ521361 RevA <br />Revision Date:9/10113 <br />