HomeMy WebLinkAboutIndustrial Wastewater Discharge Permit - Honeywell Industrial IncCITY OF SOUTH BEND JAMES MUELLER, MAYOR
DEPARTMENT OF PUBLIC WORKS
ERIC HORVATH, DIRECTOR
March 4, 2025
Board of Public Works
City of South Bend
1316 County City Building
227 West Jefferson Boulevard
South Bend IN 46601
RE: Industrial Discharge Permit Renewal
Dear Board Members:
The Division of Wastewater recommends approving the Industrial Discharge Permit Renewal for Honeywell
International Inc’s (Honeywell) Groundwater Remediation Site at the March 11, 2025, Board of Public Works
Meeting.
Honeywell has removed a soil vapor extraction system that discharged to sample location #003C00175. Sample
location #003C00175 was removed from the scope of the industrial discharge permit as well as the wastewater
treatment, pH adjustment, of the spent scrubber water generated by the soil vapor extraction system. The
removal of spent scrubber water treatment and discharge changes the requirement of certified operator level
required. No Certified Operator is required per Indiana Administrative Code (327 IAC 5-23-4).
Honeywell’s requirements were reviewed for necessary changes to ensure the industrial permit remains legally
substantiated. After review of requirements and historical data, no further changes were needed.
If you should have any questions, please do not hesitate to contact me at (574) 235-5798, or at
sshane@southbendin.gov
Sincerely,
Serena Lozano-Shane
Pretreatment Manager
City of South Bend
Division of Environmental Services, Department of Utilities
3113 Riverside Drive
South Bend, IN 46628
(574) 235-5798
sshane@southbendin.gov
Enclosure(s)
- Industrial Discharge Permit Board of Public Works Signature Page, Part I- Effluent Limitation, -Agenda
Request Form
City of South Bend
Department of Public Works
Industrial Pretreatment Program
Remediation Site – Permit No. 004
In accordance with all the terms of Chapter 17 of the City of South Bend’s Municipal Code, and with any
applicable provisions of federal or state law and regulations, permission is hereby granted to:
Honeywell International, Inc.
3502 Westmoor Street
South Bend, IN 46628
for the contribution of wastewater into the City of South Bend Publicly Owned Treatment Works.
This permit is granted in accordance with the application filed on 13 January, 2025.
Effective on: 14 April, 2025
Expires on the: 13 April, 2030
Any violation of the terms and conditions of this permit shall be deemed a violation of the City of South Bend
Municipal Code and will subject the permittee to the sanctions set out in section 17-11 through 17-13 of the
Municipal Code.
The permittee shall file an application for a renewal permit, a minimum of 90 days prior to the expiration date.
Approved By: Board of Public Works
CITY OF SOUTH BEND, INDIANA
BOARD OF PUBLIC WORKS
March 11, 2025
Honeywell Groundwater Remediation Industrial Wastewater Discharge Permit page 3 of 39
PART II - MONITORING REQUIRMENTS
Monitoring Frequency
1. The following parameters shall be monitored at the frequency and with the sampling type stated
below. All measurements, tests, and analyses of the characteristics of water and wastes to which
reference is made in this permit shall be conducted using the methods and procedures approved
in 40 CFR 136 and amendments thereto, unless otherwise specified in an applicable Categorical
Pretreatment Standard.
The following parameters shall be monitored at sample sites EW-1-R, EW-2R, EW-3R, EW-5-R, E3A, RWB-16,
and RWB-23 with the methods and at the frequency stated below:
Parameter Sampling Frequency Sampling Type
Flow, Monthly (gal) Monthly Continuously
B-TEX (ug/L) SemiAnnual Grab
Total Oil and Grease (mg/L) SemiAnnual Grab
Oil and Grease TPH (mg/L) SemiAnnual Grab
pH (SU) SemiAnnual Grab
Ammonia, nitrogen (mg/L) Once per First Year of Permit Cycle* Composite
Arsenic (mg/L) Once per First Year of Permit Cycle* Composite
BOD5 (mg/L) Once per First Year of Permit Cycle* Composite
Cadmium (mg/L) Once per First Year of Permit Cycle* Composite
Chromium (mg/L) Once per First Year of Permit Cycle* Composite
Closed Cup Flashpoint (Degrees F) Once per First Year of Permit Cycle* Grab
Copper (mg/L) Once per First Year of Permit Cycle* Composite
Cyanide (mg/L) Once per First Year of Permit Cycle* Grab
Lead (mg/L) Once per First Year of Permit Cycle* Composite
Mercury (mg/L) Once per First Year of Permit Cycle* Grab
Nickel (mg/L) Once per First Year of Permit Cycle* Composite
Organic Priority Pollutants (ug/L) Once per First Year of Permit Cycle* Grab
Phosphorus (mg/L) Once per First Year of Permit Cycle* Composite
Silver (mg/L) Once per First Year of Permit Cycle* Composite
TSS (mg/L) Once per First Year of Permit Cycle* Composite
Zinc (mg/L) Once per First Year of Permit Cycle* Composite
See Flow Measurement Requirements referenced in Part III - Reporting Requirements.
*Once per First Year Permit Cycle: Parameters with this requirement must be monitored within the first year (12
months) of each permit cycle. Please see the Board of Public Works signature page for dates of permit term.
PERMIT BRIEFING MEMO
Honeywell International – Groundwater Remediation
1. Facility Description
Honeywell International, Inc. installed the Naphtha Recovery Well System in 1978 and VOC
Recovery Well system in 1988. The Naphtha Recovery Well system was used to remove free product
from the top of the water table until no further free product was detected in 2003. The well systems
currently act as water-table depression wells to control groundwater from migrating off-site.
2. Discharge description:
The Naphtha Recovery Well system consists of three (3) recovery wells: E3A, RWB-16, and
RWB-23.
The VOC Recovery Well system consists of four (4) recovery wells: EW-1R, EW-2, EW-3 and
EW-5R.
Discharge is recorded monthly on a per well basis. The total daily average discharge is 0.053 MGD.
Maximum allowable discharge of 0.154 MGD.
3. Sample Site Description
The Naphtha System and VOC System maps indicating the well locations can be found in the
Honeywell Groundwater Remediation permit application dated January 13, 2025.
Naphtha Recovery Well System:
Monitoring is conducted at each of the three (3) operating Naphtha Recovery Wells. Samples are
collected from spigots at each well. Each discharge point has a totalizer meter to record flows.
VOC Recovery Well System:
Monitoring is conducted at each of the four (4) operating VOC Recovery Wells. Samples are
collected from spigots at each well. Each discharge point has a totalizer meter to record flows.
4. Wastewater Treatment
No wastewater treatment processes are currently utilized.
5. Classification
Honeywell International – Groundwater Remediation is classified as an Industrial User (IU) as
defined in the South Bend Municipal Code and is classified as an F category discharger since it is a
remediation site.
6. Calculation of Limits
Permit limits for Honeywell International – Groundwater Remediation’s discharge are from the
South Bend Municipal Code.
7. Monitoring Frequency
Monitoring frequencies are based South Bend’s US EPA approved industrial pretreatment program
monitoring plan.
8. Industrial Operator Certification Requirement
Operator Certification Requirement: NO REQUIREMENT
Industrial operator certification requirements are based on the criteria listed in Indiana
Administrative Code, Title 327, 5-23-4.
Permit Drafted by:
City of South Bend
Industrial Pretreatment Group
January 2025
BOARD OF PUBLIC WORKS
AGENDA ITEM REVIEW REQUEST FORM
Date 3/4/2025
Name Serena Lozano-Shane Department UTILITIES
BPW Date 3/11/2025 Phone Extension 5798
Review and Approval Required Prior to Submittal to Board Diversity Compliance
and Inclusion Officer Officer Name BPW Attorney Attorney Name
Dept. Attorney Attorney Name
Purchasing
Check the Appropriate Item Type – Required for All Submissions
Professional Services Agreement Contract Proposal
Open Market Contract Amendment/Addendum Special Purchase, QPA
Bid Opening Bid Award Req. to Advertise Title Sheet
Quote Opening Quote Award Reject Bids/Quotes
Proposal Opening C/O & PCA No. PCA
Chg. Order, No. Traffic Control Resolution
x Other: Honeywell Groundwater Industrial Discharge Permit Renewal
Required Information
Company or Vendor Name
New Vendor Yes If Yes, Approved by Purchasing
No
MBE/WBE Contractor MBE
WBE Completed E-Verify Form Attached Yes
No
Project Name
Project Number
Funding Source
Account No.
Amount
Terms of Contract
Purpose/Description _______________________________________________________________
_______________________________________________________________
___________________________________________________
For Change Orders Only
Amount of
Increase
Decrease
$
($ )
Previous Amount $
Current Percent of Change:
Increase
Decrease
%
( %)
New Amount $
Total Percent of Change:
Increase
Decrease
%
( %)
Time Extension Amount:
New Completion Date: