2. 516 South Michigan Street_COA 2026-0502 Packet

Home Browse Search

Friday, December 5, 2025 Quote #: 8393124 FARS - The Monarch - South Bend IN Page 5 of 7 Installation of these products should be performed by a qualified professional who has read and understands the product manuals and is familiar with the proper safety precautions. By Others: Installation, receiving, hanging and setting of equipment, ductwork, patching, all electrical field wiring, start-up & balance, gas or electric shutdown for fire system hook-up. Checking equipment for any signs of damage upon receipt, and if found, report it immediately to the carrier. Check that all items are accounted for and free of damage. Condenser, filter / dryer kit, refrigerant, condenser disconnect and expansion valve, for use with DX coil module, will all be provided, installed, started and warranted by others. Note: Customer is responsible for additional labor charges as a result of cooking equipment layout changes after the release of the order, union labor or prevailing wage charges, or additional trips by fire system distributor caused by jobsite delays, permits, fees or test required by local authority. Submittal will specify applicable testing and approval agencies. Hook up for the fire system must be performed in accordance with the product manual by a Factory Trained Distributor. Failure to utilize a factory trained distributor voids the product warranty. CaptiveAire Systems requirement for all field hook ups: All fire system installation materials and methods must be in accordance with the product manual, which includes but not limited to: fire system piping, gas shut-off valves, low- voltage wiring and conduit, verification of appliance coverage, and start-up and inspection procedures. CaptiveAire Systems product must be installed in accordance with installation instructions provided with equipment or available on our web site at www.captiveaire.com. Ductwork must be designed and installed in accordance with AMCA and ASHRAE standards as presented in CaptiveAire Systems "Guide to Designing Air Flow Systems", available here. Hood and Ductwork hanging brackets and angles must be supported with 1/2" - 13 TPI grade 5 (minimum) all-thread. Sandwich hanging angles and ceiling anchor points with 1/2" grade 5 (minimum) steel flat washers and 1/2" - 13 TPI grade 5 (minimum) hex nuts. A doubled hex nut configuration must be used beneath hood and duct hanging brackets and above ceiling anchors (single hex nut beneath hanging angle is only acceptable for full length and supply plenum hanging angle types). Maintain 1/4" of exposed threads beneath bottom hex nut. Torque all hex nuts to 57 ft-lbs. Reference the installation manual for additional details and limitations of all structural supports. WARRANTY Standard Product Warranty This equipment is warranted to be free from defects in materials and workmanship, under normal use and service, for a period of 2-years from date of shipment. Paragon HVAC Warranty Standard 5-year parts warranty from date of shipment, to be free from defects in materials and workmanship, under normal use and service. Paragon HVAC Extended Warranty An extended 10-year non-prorated parts warranty is available at no extra charge when units are remotely monitored and maintained through a Service Preventative Maintenance subscription (terms and conditions apply). Furnace Warranty Subject to all terms stated herein, the MANUFACTURER warrants to BUYER the stainless-steel heat exchanger to be free from defects in material and workmanship under normal use and service for 25-years from the date of manufacture and warranty is limited to replacement of the heat exchanger only. Ductwork Warranty This ductwork, chimney, and/or special gas vent system is warranted to be free from defects in material and workmanship, under normal use and service, for a period of 20-years from the date of shipment. Warranty Instructions