Laserfiche WebLink
<br />TIS 103 <br />August 20, 2025 <br />Sales: (800) 428-4442 <br />Technical: (800) 428-4511 <br />Page 2 <br />elevatecommercialbp.com <br />STORAGE <br /> Store away from sources of punctures and physical damage. <br /> Assure that structural decking will support the loads incurred by material when stored on rooftop. The <br />deck load limitations should be specified by the project designer. <br /> Store away from ignition sources as membrane will burn when exposed to open flame. <br />PRECAUTIONS <br /> Take care when moving, transporting, handling, etc. to avoid sources of punctures and physical damage. <br /> Isolate waste products, such as petroleum products, greases, oils (mineral and vegetable) and animal <br />fats from the RubberGard membrane. <br /> Refer to Safety Data Sheets (SDS) for safety information. <br />LEED® INFORMATION <br />Post-Consumer Recycled Content: 0% <br />Post Industrial Recycled Content: 0% <br />Manufacturing Location: Prescott, AR <br />NOTE: LEED® is a registered trademark of the U.S. Green Building Council <br /> <br /> <br />TYPICAL PROPERTIES (Meets or exceeds ASTM D 4637, Type I) <br />Physical Test ASTM Min. Value Typ. Value 45 mil Typ. Value 60 mil <br />Thickness (D412) <br />45 mil: 1.143 mm +0.178 mm/-0.127 mm <br />(0.045" +0.007"/-0.005") 1.092 mm (0.043") 1.37 mm (0.054″) 60 mil: 1.52 mm +0.229 mm/-0.152 mm <br />(0.060″ +0.009″/-0.006″) <br />Tensile Strength (D412, Die C) 9.0 MPa (1305 psi) Minimum 11 MPa (1600 psi) 11 MPa (1600 psi) <br />Dynamic Puncture Resistance @ 5J <br />(D5635) Pass Pass Pass <br />Static Puncture Resistance @ 20 kg <br />(D5602) Pass Pass Pass <br />Elongation, Ultimate % (D412, Die C) 300% Minimum 445% 480% <br />Tensile set (D412, Method A, Die C) 10% Maximum 0% Pass <br />Tear Resistance (D624, Die C) 26.27 kN/m (150 lbf/in) Minimum 29.60 kN/m <br />(169 lbf/in) <br />29.25 kN/m <br />(167 lbf/in) <br />Brittleness point (D2137) -45 ºC (-49 ºF) Maximum -45 °C (-49 °F) Pass <br />Ozone resistance, no cracks D1149) Pass Pass Pass <br />Tensile Strength after Heat Aging* 8.3 MPa (1205 psi) Minimum 9.48 MPa (1365 psi) Pass <br />Elongation, Ultimate after Heat <br />Aging* 200% Minimum 306% Pass <br />Tear Resistance after Heat Aging* 21.9 kN/m 125 lbf/in Minimum 33.1 kN/m (189 lbf/in) Pass <br />Linear Dimensional Change after <br />Heat Aging* ± 1% -1% Pass