Laserfiche WebLink
SURFACE PREPARATION <br />Make sure surface is properly abraded, clean, and dry <br />before application. Surface must be free of dirt, grease, <br />oil, and other contaminants. Contaminants could lead to <br />surface defects and/or poor adhesion. <br />Ensure that the floor temperature is more than 5 <br />degrees over the local dew point to avoid water <br />condensation. <br />Floor moisture should be monitored with a <br />nondestructive electronic moisture meter as per ASTM <br />F2659. Reading should be lower than 5.0% by this <br />method. <br />PRE-MIX REQUIREMENTS <br />Part A: Remove lid and mix with drill mixer for 2 minutes <br />to ensure uniformity. <br />Part B: Not required. <br />MIX RATIO: <br />2:1 mix ratio by volume (A:B) <br />MIX INSTRUCTIONS: <br />Carefully measure 2 Parts A and 1 Part B by volume and <br />blend together for 2 minutes with a drill mixer. Proceed <br />to application immediately after mixing. Never mix more <br />material than can be installed within 15 minutes. <br />APPLICATION <br />1.Using the appropriate coverage rate, mix only the <br />amount of material that can be installed within 15 <br />minutes. <br />2.To extend the working time, pour mixed material onto <br />floor in a ribbon like pattern. <br />3.Spread material evenly with a pre-wetted roller. Use a <br />chip brush to apply around the edges of the floor. 3/8” <br />nap shed resistant 18” roller and 3-4” chip brush are <br />recommended. <br />4.For Broadcast Systems: broadcast within 15 minutes <br />of the mix time. <br />5.Work time of the coating is reduced under high <br />temperature and/or humid conditions. <br />6.For detailed application instructions, refer to Penntek <br />Training Manual or contact the technical support line. <br />PRODUCT AND APPLICATION SUPPORT <br />Refer to the Penntek Training Manual or contact technical <br />support line (952-491-0616) for further information. <br />Tech Support 952-491-0616 (Call/Text) <br />techsupport@penntekcoating.com <br />7850 Lakeville BLVD, Lakeville, MN 55044 <br />Penntek.com <br />XP 275 POLYUREA/POLYURETHANE PRIMER/BASECOAT <br />T E CHN I C AL D ATA SHEE T <br />Page 2