Laserfiche WebLink
Mechanical Temporal 3 ON <br />ON <br />ON <br />—®OZ <br />Mechanical - Continuous OFF <br />ON <br />ON cf <br />M® <br />2400Hz - Temporal 3 ON <br />OFF <br />ON <br />24001-11z - Continuous OFF <br />OFF <br />ON <br />Chime - Temporal 3 ON <br />ON <br />OFF Ef <br />�® <br />Chime - Continuous OFF <br />ON <br />OFF <br />to <br />Whoop ON <br />OFF <br />OFF <br />Whoop OFF <br />OFF <br />OFF Efa'® <br />NOTE: <br />• Switch Positions 1 and 2 in the OFF position to select isolated <br />horn and strobe power inputs. <br />• Switch Position 6 ON = HIGH dBA <br />• Switch Position 6 OFF = LOW dBA <br />Zo <br />Super-Slide® <br />Mounting Bracket (2= <br />Z <br />Allows the installer to pre -wire ` <br />the system, test for system ll <br />supervision, remove the signal <br />head until occupancy, switch <br />out signals without changing <br />mounting brackets and has <br />locking edge connector for <br />snap -in place installation. <br />Candela selection slider <br />switch. Depress center <br />and slide switch to <br />desire brightness level. <br />Break off pin and inser <br />into hole at the botton <br />of the selector to loci <br />candela setting. Signa <br />must be removed fron <br />bracket and pin pushes <br />forward from backsid( <br />out of hole to chang( <br />candela. <br />Checkmate® Instant Voltage <br />Verification <br />It is often necessary to confirm the <br />voltage drop along a line of devices. <br />The access holes are provided in <br />the back of the terminal block to <br />allow the voltage to be measured <br />directly without removing the device. <br />Typically this would be done at the <br />end of the line to confirm design <br />criteria. Most measurements will be <br />taken using the S+ and S- locations <br />although access is provided to other <br />locations. <br />NOTE: Care should be taken to not <br />short the test probes. <br />To remove bezel, grip both sides <br />of bezel and pull in a downward <br />and outward motion. <br />DS1281 Revised: 28-Jan-2014 <br />Page 2 of 4 <br />