Laserfiche WebLink
DN1. FIELD VERIFY EXISTING CONDITIONS PRIOR TO START OF DEMOLITION WORK. NOTIFY GMI CONSTRUCTION REPRESENTATIVE IN WRITING OF DISCREPANCIES BETWEEN WORK SHOWN IN THE DRAWINGS AND FIELD CONDITIONS ENCOUNTERED.2. OPEN FLAME EQUIPMENT IS NOT PERMITTED FOR REMOVAL OF EXISTING WORK WITHOUT SPECIFIC WRITTEN PERMISSION FROM THE OWNER.3. COORDINATE WITH OWNER ANY ITEMS TO BE SALVAGED. 4. OWNER WILL REMOVE ALL NON-FIXED FURNISHINGS AND EQUIPMENT FROM THE CONSTRUCTION AREA PRIOR TO START OF CONSTRUCTION UNLESS NOTED OTHERWISE.5. MAINTAIN BUILDING IN A WEATHER-TIGHT CONDITION. DO NOT PERFORM WORK ON EXTERIOR OPENINGS THAT CANNOT BE COMPLETED OR MADE WEATHER-TIGHT WHEN INCLEMENT WEATHER IS POSSIBLE.6. REMOVE FLOOR MATERIALS TO THE EXTENT SHOWN OR DESCRIBED IN THE DRAWINGS. REMOVAL INCLUDES ADHESIVES, GROUTING BEDS, ANCHORING DEVICES, ASSOCIATED WALL BASE, ETC. CLEAN AND PREPARE SURFACES FOR INSTALLATION OF NEW FLOOR MATERIALS.7. SEE STRUCTURAL DRAWINGS FOR LINTELS AT NEW PENETRATIONS THROUGH EXISTING WALLS. COORDINATE PENETRATION LOCATIONS WITH ASSOCIATED TRADES.8. COORDINATE WITH OTHER TRADES CUTTING AND PATCHING REQUIRED FOR DEMOLITION OR NEW CONSTRUCTION. DEMOLITION NOTES ANY DEMOLITION OR REMOVAL INDICATED IS SHOWN IN GENERAL TO PROVIDE THE EXTENT OF DEMOLITION AND IS NOT TO BE CONSIDERED AS A RECORD DRAWING OF EXISTING CONDITIONS. THE CONTRACTOR IS RESPONSIBLE FOR IN FIELD VERIFICATION AND COORDINATION WITH THE ARCHITECT PRIOR TO COMMENCING WITH STATED WORK.9. ALL CONSTRUCTION TO REMAIN WHICH IS AFFECTED BY DEMOLITION SHALL BE PATCHED, BE PROPERLY ALIGNED, AND FINISHED SO AS TO LEAVE NO EVIDENCE OF PATCHING OR REPAIR. REPAIR OR REPLACE ANY EXISTING CONSTRUCTION, MATERIALS, OR EQUIPMENT DAMAGED DURING DEMOLITION TO LIKE NEW CONDITION.10. THE CONTRACTOR IS TO RETURN SALVAGEABLE MATERIALS, INCLUDING BUT NOT LIMITED TO DOORS, FRAMES, HARDWARE, MARBLE, EQUIPMENT, AND LIGHTING FIXTURES TO THE OWNER AND STOCKPILE THEM IN AN APPROVED CONSTRUCTION AREA. DISPOSE OF THESE MATERIALS AFTER OWNER'S REVIEW AND APPROVAL.11. CONTRACTOR IS RESPONSIBLE FOR PROTECTION OF ALL FINISHES (TO REMAIN) IN THE PROJECT AREA. COORDINATE WITH OWNER PRIOR TO DEMOLITION.12. CONTRACTOR SHALL ENSURE THAT DUST AND DEBRIS ARE PREVENTED FROM ENTERING THE EXISTING HVAC SYSTEM AND ADJOINING SPACES WITH TEMPORARY BARRIERS AS REQUIRED PER THE BUILDING.13. INDICATION OF NEW MATERIALS SHALL INFER ALL REMOVAL OR DEMOLITION AND PATCHING REQUIRED OF EXISTING MATERIALS AND SUBSTRATES FOR PROPER ALIGNMENT. MATCH EXISTING FINISHES.14. ENLARGED PLANS ARE PROVIDED IN THIS SET; SEE SHEETS DIRECTLY AFTER OVERALL PLANS.15. ONLY ITEMS CALLED OUT IN THIS SHEET SET ARE A PART OF THIS PACKAGE. ITEMS SHOWN ON SHEETS THAT ARE NOT CALLED OUT OR DETAILED ARE NOT TO BE INCLUDED IN SCOPE.16. CONDITIONS UNDERSLAB ARE UNKNOWN. AVAILABLE ORIGINAL BUILDING DRAWINGS WILL BE PROVIDED IN ADDITION TO THESE DRAWINGS, BUT HAVE NOT BEEN CONFIRMED. THEY ARE TO BE USED FOR REFERENCE ONLY. 17. WALL OPENINGS 8" AND LARGER SHALL BE COORDINATED WITH EOR FOR WALL REINFORCEMENT. WALL OPENINGS WITH MULTIPLE PIPES ADJACENT TO ONE ANOTHER WITH LESS THEN 3" BETWEEN NEED TO BE COORDIANTED WITH EOR FOR WALL REINFOCEMENT/CREATING WALL CHASE.18. SLAB AND WALLS ARE REQUIRED TO BE SCANNED FOR EXISTING UTILITIES OR OTHER EMBEDDED ITEMS PRIOR TO DEMOLITION. REFER TO SUBMITTAL SECTION ON GENERAL NOTES SHEET FOR SUBMITTAL REQUIREMENTS A. CONTRACTOR REQUIRED TO PROVIDE SLAB SCANNING FOR POSSIBLE UNDERSLAB ELECTRICAL. COORDINATE METHOD AND TIMING WITH CM TEAM.B. CONTRACTOR REQUIRED UNLESS PER-APPROVED TO PROCEED BY CM TEAM TO SCAN MASONRY WALLS PRIOR TO DEMOLITION.DEMOLITION NOTESEXISTING WALL PARTITIONSTEMPORARY WALL PARTITIONSDEMOLISHED WALL PARTITIONSDEMOLITION PLAN SYMBOLS LEGENDEXISTING DOORDEMOLISHED DOORT.4T.4T.BT.BT.CT.CT.DT.DSTAIR UP TO LEVEL 3 TO REMAINPROTECT DURING CONSTRUCTION+/- 31'-9" (VIF)12'-14' TALL16'-6"01030204050506LOW WALL TO REMAINPROTECT DURING CONSTRUCITON8'-3 49/128"2.42.409T.4T.4T.BT.BT.CT.C2.42.4DESIGN INTENTDESIGN INTENT IN THIS SPACE IS TO DEMOLISH THE STAIRCASE AND PORTION OF CURVED WALL OCCIALTALL TERAZZO FLOORING AND ALL OTHER WALLS, DOORS AND FINISHES TO REMAIN IN THIS VESTIBULE UNLESS NOTED OTHERWISEDESIGN INTENTDESIGN INTENT IN THIS SPACE IS TO DEMOLISH THE PORTION OF EXISTING WALL INDICATED WITH THE RED DASHED LINES AND REMOVE DOOR TO ALLOW FOR CREATION OF A PORTAL. ALL EXISTING DETAILING AND DESIGN PEICES REMOVED SHOULD BE SAVED FOR RE-USE. GENERAL CONTRACTOR TO COORDINATE WITH OWNER/ARCHITECT.CURVED WALL AND CROWN MOLDING, PORTION OF WAINSCOTTAPPROVED BYDRAWN BYISSUED FORISSUE DATEPROJECT NUMBERFIELD BOOK321 S. MAIN STREET. SUITE 103SOUTH BEND, IN 40661574.307.9990 -SHIVE-HATTERY.COM6543BADE1FCG2H654312BADEFCGHAutodesk Revit 2021Board of Public Works, City of South Bend, Indiana1316 County-City Building227 W. Jefferson BoulevardSouth Bend, IN 46001574-235-9251OwnerRATIO101 South Pennsylvania StreetIndianapolis, Indiana 46204317-633-4040Design Architect/ Landscape Architect/ Interior DesignStructural EngineerMechanical / Electrical EngineerCivil EngineerIntroba8250 Haverstick Road, Suite 285Indianapolis, IN 46240800-404-7677DLZ Corporation138 N. Delaware St.Indianapolis, IN 46204317-633-4120Acoustics ConsultantHaverstick Designs160 W. Carmel Dr.Carmel, IN 46032800-272-5067Lighting ConsultantShakespeare Lighting Design 1806 E. Thornton DriveBloomington, IN 47401812-320-2796Troyer GroupLandscape Architect of Record3930 Edison Lakes ParkwayMishawaka, IN 46545574-259-9976Shive-Hattery, Inc. Executive Architect/ Interior Design321 S. Main Street, Suite 103South Bend, IN 46001574-307-9990American Structurepoint, Inc.205 W. Jefferson Boulevard, Suite 404South Bend, IN 46001574-287-22315/9/2024 11:07:53 AMBIM 360://21055-Morris Performing ArtsCenter/SH-MPAC-ARCH-V21.rvtDEMOLITIONSECOND FLOORPLANS ANDDETAILSBID DOCUMENTS7211780CWNB05/09/2024A-D02RACLIN MURPHYENCORE CENTERCITY OF SOUTH BEND, INDIANA211 N MICHIGAN STSOUTH BEND, IN 46601KEYNOTES - DEMOLITION01REMOVE CURVED STAIR FROM LOWER LEVEL TO FIRSTFLOOR - INLCUDING TREADS & RISERS, RAILINGS ANDSTRUCTURE.02NEW OPENING IN EXISTING MASONRY WALL03REMOVE EXISTING WALL IN ITS ENTIRETY.04REMOVE EXISTING VANITY IN ITS ENTIRETY- CAP OFFSUPPLY AND WASTE LINES- PREP. FOR NEW CONDITIONS05REMOVE EXISTING TOLET IN ITS ENTIRETY- CAP OFFSUPPLY AND WASTE LINES- PREP. FOR NEW CONDITIONS06REMOVE TOILET PARTITION AND STALL DOOR IN ITSENTIRETY08REFER TO STRUCTURAL DRAWING FOR FLOORDEMOLITION09REFER TO STRUCTURAL DRAWINGS FOR SHORING ANDLINTELS AS REQUIRED11DOOR & DOOR FRAME TO BE REMOVED COMPLETE12STAIR SYSTEM TO BE REMOVED. WALL CONNECTION POINTTO BE PATCHED AND REPAIRED AS REQUIRED13STAIR RAIL SYSTEM TO BE REMOVED COMPLETE14PORTION OF EXISTING WALL TO BE REMOVED.COORDINATE WITH STRUCTURAL DRAWINGS15EXISTING WALL TO REMAIN01/8" = 1'-0"F6SECOND FLOOR DEMOLITION PLAN01/8" = 1'-0"F4SECOND FLOOR DEMOLITION RCP12'NOT TO SCALED62ND FLOOR DEMOLITION IMAGE CNOT TO SCALEC62ND FLOOR DEMOLITION IMAGE BNOT TO SCALEC32ND FLOOR DEMOLITION IMAGE A