Laserfiche WebLink
Typical Applications <br />Force mains/Pressure mains <br />Gravity interceptors <br />• Lift Stations <br />Biosolids processing <br />Ponds and lagoons <br />Proper dosage (as determined by Evoqua Water <br />Technologies) of BIOXIDE treatment solution to a sludge <br />or a wastewater stream, provides for a population of <br />beneficial bacteria which oxidize dissolved hydrogen <br />sulfide and other reduced sulfur compounds as part of <br />their metabolism. By treating the hydrogen sulfide both <br />in flow and solids of the wastewater stream, the process <br />prevents release of hydrogen sulfide into the air, reducing <br />odors and corrosion. <br />Typical Feed Requirements <br />Treatment is typically applied in a collection system <br />upstream of the odorous control point. From a <br />carefully selected point(s), the benefits will spread <br />throughout the collection system to the influent of the <br />treatment plant. The process has been documented <br />to reduce dissolved hydrogen sulfide from over <br />50 mg/I to < 0.1 mg/I in numerous wastewater <br />collection force mains, wet wells and gravity <br />interceptors. Similar results have been achieved with <br />BIOXIDE treatment in sludge lagoons and storage <br />tanks. Due to the biochemical nature of this process, <br />complete sulfide removal is extremely cost effective <br />in applications where extended detention times <br />produce septic conditions. <br />For additional treatment information, including dosage <br />specific to your application, please contact your Evoqua <br />Water Technologies representative. <br />0 evoQua <br />WATER TECHNOLOGIES <br />Storage and Handling <br />Bioxide solution contains no substances that are listed <br />on the Extremely Hazardous Substances (EHS) under <br />Section 302 of EPCRA or on the Extremely Hazardous <br />Substances (EHS) Release Notification under Section <br />304 of the EPCRA. Bioxide Solution is not listed as a <br />CERCLA hazardous substance. The active ingredient <br />is nitrate oxygen which is a stable compound found <br />in nature. This compound is selected as the active <br />ingredient for BIOXIDE solution because it specifically <br />interacts with naturally occurring bacteria to remove and <br />prevent dissolved sulfide, resulting in an effective, safe <br />and cost efficient product. <br />Can be stored outdoors in ambient conditions. Follow all <br />local, state and federal regulations for storage. Do not <br />dump on the ground or release into any body of water. <br />All disposal methods must be in compliance with all <br />Federal, State, Local and Provincial laws, and regulations. <br />Regulations may vary in different locations. <br />See Safety Data Sheet for additional safety and handling <br />information before storing or handling BIOXIDE solution. <br />Packaging <br />BIOXIDE solution is normally shipped in 3,800 gallon <br />bulk tanker loads. Mini bulk deliveries (<2,000 gallons) <br />are available in many parts of the country. For further <br />information, please contact your Evoqua Water <br />Technologies representative. For reorders and <br />customer service, call 1.800.345.3982. <br />210 Sixth Avenue, Suite 3300, Pittsburgh PA 15222 <br />+1(866) 91(to11-tree) +1(9)8)614-7233(toll) WWW.eyaqua.com <br />BmMc is a trademark or Evoqua, its subsidiaries or affiliates, in same counties, <br />All information presented herein is believed reliable and in accordance with accepted engineering practices. Evoqua makes no <br />warranties as to the completeness of this information. Users are responsible for evaluating Individual product suitability for <br />specific applications. Evoqua assumes no liability whatsoever for any special, indirect or consequential damages arising from the <br />sale, resale or misuse of Its products. <br />©2021 Evoqua Water Technologies LLC Subject to change without notice MS-BIOXIDE-OS-0921 <br />