Laserfiche WebLink
Version 2/14/2020 Page - 3 Public Works Quote <br />Specifications: <br />1.See electrical pages on the attached plan set. <br />2.All electrical work to be done by licensed contractor and conform to all state and federal <br />codes. <br />3.Existing electrical to be removed by electrical contractor unless noted on electrical plan <br />on next page. <br />4.Recessed can lights shall be dimming capable 6" can lights that can be mounted in <br />acoustic tiles. Acoustic ceiling by others. <br />5.All power and lighting circuits shall be minimum (2)#12, and (1)#12 g, in 3/4" c. UON. <br />6.Each single phase branch circuit conductor shall have a dedicated neutral back to the <br />panelboard. <br />7.Conceal all conduits and cables u.o.n. or approved by project manager. Where surface <br />wireway is approved, install v500 steel wiremold. <br />8.Existing conduits may be reused as appropriate. Inspect conduits and deburr prior to <br />pulling new cables. <br />9.All electrical wiring to be run in metal conduit. <br />10. For all modified circuits, field-verify any other connected loads and report to engineer if <br />not documented in these drawings. <br />11. Provide updated and typed panel directory for lp-2. <br />12. Wall-Box Dimmers: <br />a.Match dimmers in social room in building <br />b.Description: Modular, full-wave, solid-state dimmer switch with integral, quiet on- <br />off switches, with audible frequency and EMI/RFI suppression filters. <br />c.Control: Continuously adjustable toggle switch with slider; with three-way <br />switching. <br />d.Standards: Comply with UL 1472. <br />e.LED Lamp Dimmer Switches: Modular; compatible with LED fixtures to be <br />controlled by dimmer; trim potentiometer to adjust low-end dimming; capable of <br />consistent dimming with low end not greater than 10 percent of full brightness. <br />13. 4ft LED Surface Mount light for prep area. <br />a.Lithonia model FML4W485000LM840TD or equal. <br />b.Must be dimmable, 5000 lumens, and 3500K. <br />14. LED recessed cans shall be LED, dimmable, and mounted in acoustic ceiling with <br />appropriate trim. Color temperature shall be 3500K. <br />15. Contractor must coordinate work with City staff including on-site meetings as <br />necessary. <br />16.All work must be completed prior to April 1st, 2021. <br />17.A site visit is recommended and contractors may schedule a site visit by contacting the <br />project manager, Patrick Sherman, at psherman@southbendin.gov.