Laserfiche WebLink
7.8 POWER DOOR LOCK SYSTEM -ALL PATIENT AND COMPARTMENT DOORS <br />The rear patient entry doors and side entry/egress door, along with all exterior <br />compartment doors and exterior AILS door, shall be equipped with a power locks. <br />7.9 POWER DOOR LOCK SWITCHES <br />One (1) exterior power door lock switch with a rubber weather boot shall be provided <br />and installed in rear license plate bezel hidden from obvious view. It shall be in <br />addition to the switch installed in the cab to control the power door locks installed on <br />designated compartment doors. <br />YKN <br />7.9.1 Two (2) additional power door lock switches shall be provided and installed in <br />the patient compartment. One (1) shall be at the curbside entry door and one (1) at <br />the rear entry doors. <br />Y N <br />7.10 POWER DOOR LOCK ACTIVATION <br />The patient compartment door locks shall be wired to the chassis power door locks. <br />7.11 STAINLESS STEEL DOOR SILL PROTECTION <br />There shall be a 20 ga. formed stainless steel compartment doorsill protection for all <br />exterior compartments. The stainless protector shall be affixed with heavy-duty <br />double -sided tape to the top surface of the doorsill and extend over the radius edge. <br />YKN <br />7.12 COMPARTMENT ILLUMINATION <br />Each exterior compartment shall be illuminated with 4.25" round, Liteco incandescent <br />lights Model #69000200 (or equal). These lights shall have clear Lexan lenses and <br />be recessed into the compartment sides and/or ceiling above and below any <br />specified shelves. Each door shall have an individual automatic switch to signal a <br />"door or compartment open" condition and to turn on interior lighting when the door is <br />opened. The switches shall be Sentrol heavy duty, magnetic reed switches mounted <br />in the doorframe header interior to the protective door seal. <br />Y N <br />7.13 OXYGEN TANK MOUNT <br />One fully adjustable oxygen tank mount shall be installed in the exterior compartment <br />D1. This mount shall accommodate an "M" type oxygen tank. This- oxygen tank <br />retention system must meet or exceed AMD Standard 003, Oxygen Retention <br />System. <br />AN <br />7.13.1 One (1) fixed shelf shall be provided in the D1 compartment located above the <br />oxygen tank. <br />YXN <br />7.13.2 Two (2) Model # 166AH Gear Hooks shall be mounted one (1) on the forward <br />wall and one (1) on the rear wall of the D1 compartment. Exact hook placement <br />shall be determined at the pre -build meeting. YY <br />Y!\ N_ <br />7.14 ADJUSTABLE SHELVES <br />