Laserfiche WebLink
2021 International MV/PL Custom Titan 170 <br />Type I Ambulance Proposal Specification <br /> <br /> <br />A5347-0002 11/05/20 <br />25 <br /> <br />72" CEILING GRAB RAIL OVER COT: <br /> <br />A satin finish stainless steel grab rail shall be installed in the ceiling over the cot. It shall be 72" long x 1 1/4" in diameter <br />with welded stanchions every 24". It shall have fully radiused ends to eliminate a head injury hazard. The use of grab rails <br />which do not have fully welded construction is unacceptable. The grab rail shall be bolted directly to the structure <br />members of the ceiling frame work. <br /> <br />18" STAINLESS STEEL GRAB HANDLES REAR <br />DOORS: <br /> <br />One (1) 18" satin finish stainless steel grab handle shall be installed at each rear entrance door. Each shall be fabricated <br />from 1 1/4" diameter tube and have radiused ends, which match the over -head grab rail. <br /> <br />SIDE ENTRANCE DOOR GRAB RAIL, 45 DEGREE: <br /> <br />The side entrance door shall be equipped with a custom built 45 degree grab handle which extends from under the door <br />window in the horizontal plane and then diagonally to the lower outside corner of the door. The grab rail shall be <br />fabricated from satin finish stainless steel 1 1/4" diameter tube with fully welded construction. The gra b handle shall be <br />bolted directly to the structural members with the door with the use 1/4-20 threaded fasteners. <br /> <br />REAR ENTRANCE DOOR GRAB RAILS, 45 DEGREE: <br /> <br />The rear entrance doors shall be equipped with two custom built 45 degree grab handle which ex tends from under the <br />door window in the horizontal plane and then diagonally to the lower outside corner of the door. The grab rails shall be <br />fabricated from satin finish stainless steel 1 1/4" diameter tube with fully welded construction. The grab handl es shall be <br />bolted directly to the structural members with the door with the use 1/4-20 threaded fasteners. <br /> <br />18"STAINLESS STEEL GRAB HANDLE EXTERIOR <br />SIDE DOOR: <br /> <br />The side entrance door shall be equipped with One (1) 18" satin finish stainless steel grab handle installed left of the <br />exterior side of the entrance door. It shall be fabricated from 1 1/4" diameter tube and have radiused ends. <br /> <br /> <br />SEAT BELTS <br /> <br />SEAT BELT, ALL MODULE LOCATIONS: <br /> <br />All seating locations shall be provided with Valor seating and include 4 point harness systems. The seats and seat belt <br />mount shall be tested to F.M.V.S.S. 210 and Federal Specifications KKK-A-1822, Change Notice 8. Documentation shall <br />be available upon request. <br /> <br /> <br />COT MOUNTING <br /> <br />MOUNTING OF STRYKER POWER LOAD SYSTEM <br /> <br />Dealer shall provide and install a Stryker PowerLoad cot mounting system. <br /> <br />