Opening of Bids - One (1) or More, 2020 or Newer, Emergency Medical Vehicle – Spec P - Crossroads Ambulance Sales & Service, LLC

Home Browse Search

One (1) adjustable shelf will be provided and installed in the D-2 compartment. Each shall be easily adjusted to accommodate equipment/supply requi rements . vLN_ 7.14.1 Two (2) adjustable shelves shall be provided in the 04 compartment. They shall be easily adjusted to accommodate equipment/supply requirements. / y_/_NN_ 7.14.2 One (1) adjustable shelf shall be provided in P-5 compartment fore of the back board divider. 7.15 BACKBOARD DIVIDER One (1) vertical, 55n x 17.5nx .125" smooth alum inum backboard divider shall be through the inboard wall of Compartment P-5. It shall be positioned vertically 1 O" forward of the rear wall. To provide protection for the equipment retained in the compartment, the divider shall be Line~X coated. 7.16 SCBA MOUNTING PLATE The mounting plate shall be 24" high and run the full width of the compartment. The mounting plate shall be made of 3/16" smooth aluminum with rolled top and edges and have a 3/4" lip. There shall be a 1" x 2" aluminum tube welded to the back of the SCBA plate and mounted to the lower rear wall of the 04 compartment. 7.17 EQUIPMENT RETAINERS Three (3) seatbelt style retai ner straps shall be provided and installed in the PS exterior compartment. One (1) sha ll be located in the aft section 40" from the floor and two (2) located in the fore section 17" and 54" from the floor. / YLN_ 7 .17 .1 A slide out stair chair holder for a Stryker model # 6252 stair chair shall be provided in the aft section of the PS compartment under the adjustable shelf. The holder shall be constructed of .125" smooth aluminum with the entire holder covered with black Line-X bed-liner type material. The back shall be 38" high, the front shall be at a slight outward angle and be 27" high. It shall be 22" wide and 9" deep. Dimensions shall allow for easy removal of device from holder. A seat belt style retaining strap shall be secured to the back with footman loops. The stair chair holder shall be mounted into the compartment with two (2) 300 lbs., full extension ball bearing drawer sl ide~ YLN __ 7.18 SAFETY REFLECTORS A 4.5" wide x 1" high red reflector shall be provided and installed on the inside, lower outboard area of each exterior door. These reflectors shall warn oncoming traffic of t the open door while on scene. y N_ 7.19 GRAB RAIL An exterior style 16" stainless steel grab ra il shall be installed on the curbside of the vehicle to the rear of the curbside entrance door. The grab rail shall be bolted through the body skin and through the aluminum side structure with fender washers