Laserfiche WebLink
5.3.2 Two (2) Whelen 700 Series red Supe r LED li ghts, each w ith an integral 7E <br />fl ange and a c lear lens sha ll be provided and mounted one (1) direct ly above each <br />rear wheel well. <br />5.4 SCENE LIGHTS <br />There shall be three (3) Whelen 24 LED 900 Series 8 -32~degree scene light installed <br />on each side of the body. Each scene light shall have a clear lens w ith d irectional <br />LEDs to cast downward illumination. Each s ide shall be independently lighted and <br />switched separ ately in the driver's switch cons ole. The li ghts shall be a minimum of <br />75" above the ground and not obstructed by open doors. <br />The scene lights shall meet the current AMO Standard 024-Scene Light <br />y ~- <br />Performance. / <br />6.4.1 The two (2) curbside scene lights shall activate when the side entry door is <br />opened and the (2) rearmost scene lights shall activate when the vehicle is placed in <br />reverse. <br />5.5 REAR BODY LIGHTS <br />Three (3) Whelen 900 Series Super LED lights with clear lenses shall be installed. <br />Two (2) shall be red Super-LEDs, model 90RR5SRR, surface mounted on the upper <br />rear module body corners. One (1) shall be an amber Super-LED, model 90AA5SAA, <br />surface mounted on the upper rear module body center. <br />5.6 LOAD LIGHTS <br />Two (2) Whe len 900 Se ries model #9SCOENZR Opti-S cen e 8-32-degree LED load lights w ith <br />flanges shall be located above the rear doors . Each light shall have an inner lens giving a <br />downward cast to the light beam and activate when the rear doors are open ed or the vehicle <br />is placed in reverse gear. There shall also be a switch on the driver's console to activate the <br />rear load lights when the doors are closed. The lights shall be a minimum of 75 " above the <br />ground and not obstructed by open doors. <br />5.7 RUBRAIL LIGHTS <br />S ix (6) Whelen LED Strip-Lite lights shall be provided and mounted in the C-Channel <br />rub rails. One (1) red in each forward and rearward corner and one (1) white center <br />shall be provided on both sides of the body. The side entry door C -Channel rub rail <br />light shall activate to steady burn with opening of the side entry door. These Lights <br />shall be installed in the C-channel rub rail to provide protection for this warning light. <br />Due to this being a high wear area of the vehicle, installation of the lights above or <br />Y{-N_ <br />v_b_ <br />v_6_ <br />v.J_N_ <br />below t he rub rail are more exposed to damage and unacceptable / <br />YLN_ <br />5.8 WARNING LIGHT FLASH REQUIREMENTS <br />Within the flash pattern established for each light or light group by KKK-A -1822F,