Laserfiche WebLink
Y___N___ <br />11.11.2 A full length aluminum handle shall be provided on each door. <br /> Y___N___ <br /> <br /> <br />11.12 SUPPLY CABINET <br /> <br />A supply cabinet shall be provided in the rearward section of the street side interior, <br />below the overhead cabinet. It shall be accessible from both the interior and the <br />exterior (D4) compartment. <br /> Y___N___ <br />11.12.1 It shall have vertically hinged, swing-out doors backed with aluminum <br />diamond plate. <br /> Y___N___ <br />11.12.2 A stainless Steel Round Southco latch (or equal) with a roller ball catch shall <br />be provided on each door. <br /> Y___N___ <br />12.0 KNOX EMS DRUG VAULT STREETSIDE CABINET <br /> <br />One (1) customer supplied Knox Med Vault model #5502 shall be installed in the street side <br />cabinet. Exact location shall be determined at pre-build. A 12-volt constant power source shall <br />be supplied to the installation area. <br /> Y___N___ <br />13.0 PATIENT COMPARTMENT EXHAUST VENT <br /> <br />Detmar #751 A (or equal) three-speed power exhaust vent having a 240-cfm air flow <br />rating shall be installed in the upper left side rear wall, with approximate dimensions <br />of 6" wide x 8" high. The resister coil shall be mounted in the fan air flow. A switch <br />shall be mounted at the right hand of the technician in the action area switch <br />console. A positive closure to prevent destabilization of the patient compartment <br />shall be provided. <br /> <br /> Y___N___ <br />14.0 OXYGEN COMPARTMENT <br /> <br />The oxygen cylinder storage compartment shall be located in the street side front <br />compartment D1. Access to the regulator, contents gauge, and cylinder shut-off <br />valve from the interior of the vehicle shall be by means of a hinged .250” thick <br />Plexiglas® door in the forward wall of the action area. This opening shall be trimmed <br />with a black, ABS formed bezel to protect the Technician’s hands and provide a <br />finished opening. The compartment shall be vented through the exterior door with a <br />minimum 28 square inch opening. The vent opening shall be covered with a <br />polished aluminum vent cover. It shall be attached with stainless screws. The <br />oxygen cylinder retention bracket shall be mounted to the wall of the compartment by <br />Grade 8 bolts tapped into a .250” aluminum plate welded onto the inboard side of the <br />compartment wall. This retention bracket must meet or exceed AMD Standard 003, <br />Oxygen Retention System. The finished oxygen system including regulator, contents <br />gauge, hoses, outlets and flow meter must meet or exceed the requirements of AMD <br />Standard 015, Ambulance Main Oxygen System Test. <br /> Y___N___ <br />15.0 WIRING MODULE <br /> <br />An angled cabinet forward of the rear facing Technician’s seat shall house the main <br />bank of electrical components. Adequate ventilation shall be supplied through two (2) <br />polished metal, louvered vents located near the top and bottom of the door. <br /> Y___N___