Opening of Bids - One (1) or More, 2020 or Newer, Emergency Medical Vehicle – Spec P - American Response Vehicles

Home Browse Search

American Response Vehicles 35 UltraView™ 450: The UltraView™ 450 display (UV450) is a custom programmed, 4.3 inch, full color LCD ES-Key display. It is an 8 button, touch screen capable display. The LCD is bonded for direct sunlight view ability. The UV450 is sealed to IP67 and allows for flexible mounting options (flush, pedestal, or rear). The UV450 has 2 J1939 CAN Bus connections and 2 NTSC/PAL Video inputs. The UV450 switches are configured to allow for the control of emergency master and non-emergency master functions and are completely configurable VIA the ES-Key™ Professional software. Switches may be set to act as momentary, maintained or 3 way switches without any physical hardware change. All switches and or indicators may be configured as touch screen inputs into the ES-Key™ system. The 8 buttons are LED backlit. The UV450 display contains ES-Key™ diagnostics, allows viewing of vehicle voltage, current draw, oxygen remaining, date and time, climate control status, temperature and control, elapsed time counter, and warning messages. Super node II™: The Super node II™ is a high density input output node that is part of the Class 1 Inc. ES-Key™ system. The Super node II™ has 24 inputs (8 positive/8 negative), 24 outputs, a Universal System Manager, a Data logger, programmable special utilities, and select J1939 engine and drive train message reception with ES-Key™ I/O association. There are 18 positive and 6 negative outputs in the Super node™. Each positive output is capable of 13 amps continuous duty. The negative outputs are capable of 2 amps continuous duty. There is an LED associated with each input and output to indicate the inputs and outputs are physically on. Super node II™ outputs contain features such as digital circuit breaker, flash capability, PWM capability and open load detection. Each positive output has a digital circuit breaker feature. The "digital circuit breaker" feature will automatically turn OFF an output within 0.5 seconds when the source current exceeds 14 Amps. The Super node II™ will attempt to reconnect the output to the load twice more at 5 second intervals, if the output is still overloaded the Super Node will maintain the output OFF. Outputs 0 7 have a “digital circuit breaker - slow blow” which dynamically adjusts the time frame the output stays active when the load exceeds 13 Amps. This feature synthesizes the opening of a standard fuse when reacting to overload conditions. A load of 13.5 Amps will automatically turn off after approximately 12 seconds, and a load of 26 Amps will automatically turn off after approximately 3 seconds. The "digital circuit breaker" feature can be reset (or reinitialized) by de- activating the output through the ES-Key TM network. When the output is turned back ON, the over current tests will be initiated. When an output switch is in an over current situation, a fault is logged to the USM and data logger functions of the Super Node. Outputs 0 through 17 are flash capable at 2 different rates and pulses (allowing for alternating synchronized flash patterns). Additionally, any output in the ES-Key™ network may be flashed at intervals of .25 seconds utilizing Super node™ special utility functions. Outputs 10 through 17 may be pulse width modulated (PWM) to control loads at a reduced power. PWM may be used as a light dimming feature. An output set to its PWM state will drive its load at 60% duty cycle at 400HZ.