Laserfiche WebLink
American Response Vehicles <br />16 <br />Engineering will determine the amount of these vents required by the volume of space in the compartment. <br /> <br />SHELF BRACKET: Each exterior adjustable shelf listed below will include four (4) self-gusseted .157” thick shelf <br />brackets that will allow for easy adjustment up and down for each shelf. Each bracket will be secured to the <br />shelf by carriage head bolts on the top of the shelf and hex head bolts to secure them to the shelf tracking <br />material in the compartments. This will guard against shelf deformation in the compartments when the shelves <br />are secured in place. <br /> <br />CURB SIDE ACCESS DOOR: The curbside access door will be at least 78.8" high by 32" wide measured at the <br />door jamb opening. <br /> <br />JAMB PROTECTION: At the curbside module entry door, a full width, formed, stainless steel jamb protection <br />plate will be provided to prevent heavy traffic from chipping the paint. <br /> <br />DOOR CHECK: The curbside entry door will be equipped with a door check (hold open) device. All vertically <br />hinged doors in excess of 13" pass through width will have a gas operated bi-directional spring shock door <br />check. Door check brackets will be drilled and tapped through a minimum of 3/8" material to preclude coming <br />loose. <br /> <br />DOOR SWING: The compartment door checks will be installed to allow the door to open ninety to 100 <br />degrees (90 up to 100) from the fully closed position. <br /> <br />CURB SIDE ACCESS DOOR LOCATION: The module side entry door will be located on the curbside of the <br />module, just rearward of the ALS cabinet to provide efficient egress into the module. <br /> <br />STEP WELL: A curbside entry door will feature a double step "step well" to assist in patient cabin egress. The <br />step will have a tread dimension of not less than 10 inches. The riser dimension will not exceed nine and one- <br />half inches, measured from the step tread to the floor of the patient cabin. A right angled trim, made of bright <br />aluminum diamond plate, will be formed over the flooring material and wrap around the 3-sided perimeter of <br />the step well. Step well material will be 0.100 thick, Polished aluminum diamond plate. The step well will be <br />illuminated. The step well will meet or exceed the current revision of Federal specification KKK-A-1822. <br /> <br />STEP WELL ILLUMINATION: There will be two (2) 3" LED clear interior lights that will illuminate the curbside <br />step well per the current revision of Federal specification KKK-A-1822. There will be one (1) light for each step. <br /> <br />WALK THROUGH: Walk through access from the module to the cab will be provided. The walk through <br />opening will be at least 19" inches wide and 41" inches high. The cab will NOT be rigidly fastened to the <br />modular body. A flexible, Accordion shaped, closed cell rubber bellows, custom made for the opening will be <br />provided to tie the cab to the module. One joint in the bellows is acceptable and will be located on the <br />bottom of the opening. The joint will be completely vulcanized. <br /> <br />TRANSITION THRESHOLD: There will be installed a metal transition plate at module interior for the cab to <br />module connections that are generalized as Walk-thru. This metal plate is to provide a stepping surface for EMT