Opening of Bids - Two (2) More or Less Custom Rear Mount Pumpers Spec C - Sentinel Emergency Solutions

Home Browse Search

South Bend Fire Department CommanderChassis support structure shall consist of 1/8” thick x 2” 6061-T6 Aluminum tubes and the horizontal hat sections shall consist of 1/8” thick x 4” 5052-H32Aluminum. The dual vertical support sections shall be 40” a-part, and the cab shall contain a minimum of four (4) 4” hat section horizontal supports. Additionally, the rearedge of the floor shall include a 3/16” 6061-T6Aluminum tube extrusion (under the floor) anda 7” 5052-H32 Aluminum cab floor support section (above the floor) The outside cab width shall measure 99” across. The interior cab shall have a width of 93". The cab length shall measure 77.3” from the center of the frontaxle to the front cab skin and 60” from center of the frontaxle to the back of thecab, for a total cab length of137.3”. The cab shall also feature ample driverand officerfoot room, a total of 3.7 squarefeet for the driver and 4.45 squarefeet of floor space at the officer’sfeet.(No exceptions) The crew floor shall feature a complete flat floordesign, including provisions for a one o'clock PTO inclusion, while still offering an uninterrupted 25 total square feet of space. The leading edge of the cab floor from the steps shall meet NFPA 15.7.4 slip resistance requirements on both thefront and rearcab doors. No Exceptions. The cab shall meet or exceedcab impact test (SAE J-2420, cab rollover test (SAE J2422), and cab seating requirements(FMVSS 210, and FMVSS 208). The cab shall include 4 doors. They shall havea front two (2) cab doors shall have a minimum clear opening of 42.5" wide by 81” high measured from the top of the lower cab step to the top of the door opening.; and the rear two (2)crewdoors shall be a minimum clear door opening of 38.5" wide by 89” high measured from the top of the lower cab step to the top of the door opening. The length of the door will vary depending on door type. ROOF STYLE - 8" RAISED The cabroof design shall incorporatean angledfront roof, transitioning into a rolled extrusion for a swept back design. The roof height shall feature an 8" raise starting over the driver and officer positions and continuing back to the roof and rearwall joint.Raised roof designs that do not include a raised portion over the driver and officer positions will not be acceptable. No Exceptions. The roof of the cab shall feature dual .25" thick interlocked structural member extrusions running the entire width of thecab defending against buckling in the event of a rollover. 10039-001609/02/20 8 PDF created with pdfFactory Pro trial version www.pdffactory.com