Laserfiche WebLink
HEADSET HANGERS <br />There will be four (4) headset hanger(s) installed driver's seat, officer's seat, driver's side outboard <br />forward facing seat and passenger's side outboard forward facing seat. The hanger(s) will meet NFPA <br />1901, Section 14.1.11, requirement for equipment mounting. <br />TWO WAY RADIO INSTALLATION <br />There will be two (2) customer supplied two way radio(s) sent to the apparatus manufacturers preferred <br />radio installer to be installed tbd per the shipping document. <br />No antenna mount or whip will be included in this option. <br />Specific radio shipping requirements will be followed. <br />RADIO ANTENNA MOUNT <br />There will be two (2) standard 1.125", 18 thread antenna -mounting base(s) installed on the right side on <br />the cab roof with high efficiency, low loss, coaxial cable(s) routed to the instrument panel area. A <br />weatherproof cap will be installed on the mount. <br />VEHICLE CAMERA SYSTEM <br />There will be a color vehicle camera system provided with the following: <br />• One (1) camera located at the rear of the apparatus, pointing rearward, displayed automatically <br />with the vehicle in reverse <br />The camera images will be displayed on the driver's vehicle information center display. Audio from the <br />microphone on the active camera will be not provided. <br />The following components will be included: <br />• One (1) SV-CW134639CAI, camera <br />• One (1) amplified speaker (if applicable) <br />• All necessary cables <br />ELECTRICAL POWER CONTROL SYSTEM <br />The primary power distribution will be located forward of the officer's seating position and be easily <br />accessible while standing on the ground for simplified maintenance and troubleshooting. Additional <br />electrical distribution centers will be provided throughout the vehicle to house the vehicle's electrical <br />power, circuit protection, and control components. The electrical distribution centers will be located <br />strategically throughout the vehicle to minimize wire length. For ease of maintenance, all electrical <br />distribution centers will be easily accessible. All distribution centers containing fuses, circuit breakers <br />and/or relays will be easily accessible. <br />Distribution centers located throughout the vehicle will contain battery powered studs for supplying <br />customer installed equipment thus providing a lower cost of ownership. <br />Circuit protection devices, which conform to SAE standards, will be utilized to protect electrical circuits. <br />All circuit protection devices will be rated per NFPA requirements to prevent wire and component <br />damage when subjected to extreme current overload. General protection circuit breakers will be Type -I <br />43 of 89 <br />