Laserfiche WebLink
• PS Cab Door Open (Passenger's Side Cab Door Open) <br />• DS Crew Cab Door Open (Driver Side Crew Cab Door Open) <br />• PS Crew Cab Door Open (Passenger's Side Crew Cab Door Open) <br />• DS Body Door Open (Driver Side Body Door Open) <br />• PS Body Door Open (Passenger's Side Body Door Open) <br />• Rear Body Door Open <br />• DS Ladder Rack Down (Driver Side Ladder Rack Down) <br />• PS Ladder Rack Down (Passenger Side Ladder Rack Down) <br />• Deck Gun Not Stowed <br />• Lt Tower Not Stowed (Light Tower Not Stowed) <br />• Fold Tank Not Stowed (Fold -A -Tank Not Stowed) <br />• Aerial Not Stowed (Aerial Device Not Stowed) <br />• Stabilizer Not Stowed <br />• Steps Not Stowed <br />• Handrail Not Stowed <br />Any other device that is opened, extended, or deployed that creates a hazard or is likely to cause major <br />damage to the apparatus if the apparatus is moved will be displayed as a caution message after the <br />parking brake is disengaged. <br />SWITCH PANELS <br />The built-in switch panels will be located in the lower console or overhead console of the cab. <br />The switches will be rocker -type and include an integral indicator light. For quick, visual indication the <br />switch will be illuminated whenever the switch is active. A 2-ply, scratch resistant laser engraved <br />Gravoply label indicating the use of each switch will be placed below the switches. The label will allow <br />light to pass through the letters for improved visibility in low light conditions. Switches and light source <br />are integral to the switch panel assembly. <br />WIPER CONTROL <br />Wiper control will consist of a two (2)-speed windshield wiper control with intermittent feature and <br />windshield washer controls. <br />SPARE CIRCUIT <br />There will be four (4) pair of wires, including a positive and a negative, installed on the apparatus. <br />The above wires will have the following features; <br />• The positive wire will be connected directly to the battery power <br />• The negative wire will be connected to ground <br />• Wires will be protected to 15 amps at 12 volts DC <br />• Power and ground will terminate officer side dash area <br />• Termination will be with heat shrinkable butt splicing <br />• Wires will be sized to 125 percent of the protection <br />The circuit(s) may be load managed when the parking brake is set. <br />36 of 89 <br />