Opening of Bids - Seitz Park Reconstruction Phase I Proj No. 117-093A - Northern Indiana Construction Co., Inc.

Home Browse Search

I . All battery cables and battery harnesses shall have a permanent label attached for easy identification of the harness part number and fabrication date. 2. Splices shall not be allowed on battery cables or battery cable harnesses. 3. For ease of identification and simplified use, battery cables shall be color coded. All positive battery cables shall be red in color or wrapped in red loom the entire length of the cable. All negative battery cables shall be black in color. 4. For ease of identification, all positive battery cable isolated studs throughout the cab and chassis shall be red in color. 5. For increased reliability and reduced maintenance, all electrical buss bars located on the exterior of the apparatus shall be coated to prevent corrosion. ELECTRICAL COMPONENT INSTALLATION All lighting used on the apparatus shall be, at a minimum, a two (2) wire light grounded through a wired connection to the battery system. Lights using an apparatus metal structure for grounding shall not be allowed. An operational test shall be conducted to ensure that any equipment that is permanently attached to the electrical system is properly connected and in working order. The results of the tests shall be recorded and provided to the purchaser at time of delivery. ;TEP LIGHTS Four (4) white LED, step lights shall be provided. One (1) step light shall be provided on each side, on the front compartment face and two (2) step lights at the rear to illuminate the tailboard. In order to ensure exceptional illumination, each light shall provide a minimum of 25 foot- candles (fc) covering an entire 15" x 15" square placed ten (10) inches below the light and a minimum of 1.5 fc covering an entire 30" x 30" square at the same ten (10) inch distance below the light. These step lights shall be actuated with the pump panel light switch. All other steps on the apparatus shall be illuminated per the current edition of NFPA 1901. TEAR FMVSS LIGHTING The rear stop/tail and directional LED lighting shall consist of the following: Two (2) Whelen Model M6BTT red LED stop/taillights. Two (2) Whelen Model M6T amber LED arrowturn lights. Each light shall be installed in a housing and include colored lenses. Four (4) red reflectors shall be provided. A license plate bracket shall be mounted on the driver's side above the warning lights. An LED step lamp shall illuminate the license plate. 3ACKUP LIGHTS There shall be two (2) Whelen, Model: M6BUW, LED backup lights provided in the tailligl housing. REAR ID/MARKERDOT LIGHTING There shall be one (1) three (3) LED light kit used as identification lights located at the rear of the apparatus per the following;