Laserfiche WebLink
INSTALLING PANELS <br /> Min. 1/4"gap • Panels install left to right. <br /> • • • Install the first panel locking it down onto the <br /> starter strip and keeping the left end of the panel ' <br /> 3/8" away from the furring strip. <br /> - lir"Siggillillii-11 .11.1.111111.11111111 <br /> • Fasten the panels by placing fasteners in the <br /> nailing flange; one in the center of the panel and <br /> 141 <br /> two on either side, evenly placed. Keep fasteners <br /> approximately 2" in from both ends. (Fig. 6). <br /> II3/8" Gap <br /> Min. '/:" coverage ` Fig 5 1 5 fasteners per full panel <br /> INSIDE CORNER POSTS <br /> Inside corner posts are the only finish "trim" piece to <br /> 6 <br /> be installed prior to the Fig. -4(siding panels. i J <br /> • Install any inside • Install the remainder of the course overlapping <br /> corners. Fasten thethe seams and leaving the necessary space <br /> r <br /> inside corners using between the shakes. If the temperature is above <br /> weather resistant 70°F leave 1/8", if the temperature is below 70°F <br /> screws placed inside Install inside corners leave 1/4" (Fig. 8) <br /> the pocket of the prior to siding <br /> corner no more than 1/8" Gap above 70°F <br /> 16" apart. Unlike the . 1/4" Gap Below 70°F <br /> other finished trim, <br /> inside corners are applied beforeth 'I, <br /> siding. <br /> NOTE: Make sure not to <br /> draw the pocket in when fastening to the wall. <br /> The pocket width must remain 3/4". Use a scrap <br /> piece of siding as a spacer in the pocket. The y_ ._— <br /> inside of the corner post should not lay against the I �' <br /> siding. 1 I - ?--Fig.. 10 <br /> 40 41 <br />