Laserfiche WebLink
TRIM INSTALLATION <br /> • Install trim over furring strips (Fig. 10-11). It is <br /> FINAL PANEL INSTALLATION easiest to assemble window and door trims <br /> before applying them to the wall. When using <br /> • <br /> • Measure for the last panel by measuring from Celect trim, be sure to build the trim slightly <br /> above the nailing hem of the next to last panel to larger (1/8" each side)than the window or door <br /> the chalk line and add 1-1/2". to give the finished frame room to expand and <br /> • Measure from the batten strip side of the last contract through temperature changes. <br /> panel and cut. � Cortexes or Pro Plug screws and matching plugs <br /> • Prior to installing the panel, pre-drill a hole within should be used when installing Celect trim. <br /> 12" of the bottom of the panel to hold it in place. Space the fasteners no more than 16" apart <br /> of the fastener. <br /> the hole should be slightly larger than the shaft and no closer than 2" from the end of the trim. <br /> Make sure not to fasten through the siding or <br /> • Install the panel and place a fastener through the into the expansion pocket (Fig 11). <br /> pre-drilled hole. Note: See trim assembly section for more. <br /> • Continue to secure the panel by placing fasteners <br /> along the cut edge of the panel at 8"-12" <br /> intervals. The fastener head will hold the panel <br /> back. do not fasten tightly and do NOT place the <br /> fasteners through the panel (Fig. 9). 'x' <br /> Ail <br /> SU SCREW SET PLUG <br /> i <br /> i likt, 1 <br /> - - -_ - - iCortiddenFastening System <br /> Mk <br /> 1i I �I It.i <br /> i Fig. 10 <br /> -11 <br /> ll <br /> . i <br /> 41 <br /> ,, illit. .,,, <br /> .( <br /> 61;/�1111� <br /> Fig. 9 'ki- d( " �s <br /> .)/ Fig. 1 <br /> 37 <br /> 36 <br />