Laserfiche WebLink
INSTALLING PANELS <br /> Min. '/4"gap \ • Panels install left to right. <br /> • Install the first panel locking it down onto the <br /> 1 14 ,_ ' .-....,,.,,,.,,,,„,. *4*'.%3/44.''' <br /> starter strip and keeping the left end of the panel <br /> 3/8" away from the furring strip. <br /> • Fasten the panels by placing fasteners in the <br /> nailing flange; one in the center of the panel and <br /> two on either side, evenly placed. Keep fasteners <br /> • approximately 2" in from both ends. (Fig. 6). <br /> 1 <br /> 3/8" Gap <br /> Min. 1/2" coverage ` Fig 5, i 5 fasteners per full panel <br /> .-_ . _ _-� <br /> INSIDE CORNER POSTS <br /> Inside corner posts are the only finish "trim" piece to ,� <br /> be installed prior to the Fig. 6 4, <br /> ,'r <br /> siding panels. r v, <br /> • Install any inside 04 •• Install the remainder of the course overlapping <br /> corners. Fasten the the seams and leaving the necessary space <br /> inside corners using between the shakes. If the temperature is above <br /> weather resistant 70°F leave 1/8", if the temperature is below 70°F <br /> screws placed inside Install inside corners leave 1/4" (Fig. 8) <br /> the pocket of the prior to siding <br /> corner no more than r 1/8" Gap above 70°F <br /> 16" apart. Unlike the 1/4" Gap Below 70°F <br /> other finished trim, %,Y . <br /> inside corners are r N.y <br /> applied before th Fig. 5 4.14,—. <br /> siding. <br /> NOTE: Make sure not to <br /> draw the pocket in when fastening to the wall. <br /> The pocket width must remain 3/4". Use a scrap <br /> piece of siding as a spacer in the pocket. The _. + <br /> inside of the corner post should not lay against the { I <br /> siding. I i --- I .---Fig. . 10 <br /> J <br /> 40 41 <br />