Laserfiche WebLink
Q: June 1 st seems like an aggressive schedule - assuming award / contract might take a week or <br />two that is a likely start date of May l st-ish (not assuming any issues with starting due to Covid). <br />Assuming we have to wait for cure times for coating etc. - Is June I st completion set in stone? <br />Q: Would like to know of the new time line could be extended to 8 weeks? <br />A: The project will have a substantial completion date ofJunw4 July :3 and a final completion <br />date ofJ-une &July l 0. During all work, the Contractor may close Levels 4 and 5, maintaining a <br />drive lane up to Levels 6 and i. The contract time will start when the Notice to Proceed is <br />delivered and signed. <br />Q: Is this a prevailing wage project and was the pre bid attendance mandatory? <br />A: No and No. <br />Q: Paint removal is down to bare concrete or just what is loose? <br />A: See Section 09 9100 — 5 in the specifications for expectation of preparing surfaces. <br />E. Preparation of coated and uncoated concrete surfaces: <br />1. Concrete surfaces shall be waterblasted as a minimum to remove contaminants <br />and loose paint. Scraping of the loose paint may be required. <br />2. Surfaces shall be cleaned, dry, and free of all contaminants such as dirt, dust, <br />laitance, grease, previously applied coatings and other contaminants that would <br />interfere with the adhesion of the specified coating system. <br />3. Properly prepared surfaces shall be dry prior to coating. <br />4. New concrete shall cure for minimum of 28 days prior to coating, or as <br />required by Manufacturer <br />Attachments: <br />® Minority and Women Business Enterprise Diversity Development Program General <br />Conditions <br />® Minority and Women Business Enterprise Diversity Development Program forms <br />• Typical Level Image <br />• Wall Delamination Image <br />® Unpainted Column Image <br />-This addendum consists of a total 10 pages inclusive of "Acknowledgement of Receipt of <br />Addendum" sheet- <br />