Laserfiche WebLink
PRODUCT SPECIFICATION <br />The following Quality Assurance tests are performed according to ASTM procedures. <br />Material Testing <br />1. Melt Flow Index Test: To check that the polymer batch matches the supplier <br />certification. This is testing procedure ASTM D1238. <br />2. Colorant Color Match: Compare lot based color chips to the color chip master to <br />ensure consistency. <br />In -Process Qualitv Tests <br />1. Drop Test: Cart is raised 12' under load and dropped 4 consecutive times. This <br />provides that there is not a processing issue. <br />a. 95 gallon- 335lbs <br />2. Bib Pull Test: Bib pulled to failure to evaluate brittleness. Bib should break tensile. <br />3. Bar Pull Test: Bar pulled to failure. Determines if there is weakness at knit line at <br />center of plastic bar. Bar should break off center. <br />4. Fit Checks: Mating components (axle, lift bar, lid) installed onto carts after cooled <br />to ensure proper fit, form & function. <br />5. Weight & Thickness Checks: Evaluates molding process. <br />All designs, specifications, and components are subject to change at the manufacturer's <br />sole discretion at any time without notice. Data published herein is informational in nature <br />and shall not be construed to warranty suitability of the unit for any particular purpose as <br />performance may vary with the conditions encountered. <br />REV UIt2 PAGE 6o16 <br />00 O ITO ENVIRONMENTAL, SYSTEMS \ORTI I ANI[FRICA, INC�� � <br />