My WebLink
|
Help
|
About
|
Sign Out
Home
Browse
Search
Ben and Carrie Modlin vs. Historic Preservation Commission (COA#2019-1007A)
sbend
>
Public
>
Common Council
>
Legislation
>
Upcoming Bills
>
2020
>
03-23-2020
>
Ben and Carrie Modlin vs. Historic Preservation Commission (COA#2019-1007A)
Metadata
Thumbnails
Annotations
Entry Properties
Last modified
3/2/2020 10:43:36 AM
Creation date
3/10/2020 4:12:21 PM
Metadata
Fields
Template:
City Council - City Clerk
City Counci - Date
3/9/2020
Jump to thumbnail
< previous set
next set >
There are no annotations on this page.
Document management portal powered by Laserfiche WebLink 9 © 1998-2015
Laserfiche.
All rights reserved.
/
600
PDF
Print
Pages to print
Enter page numbers and/or page ranges separated by commas. For example, 1,3,5-12.
After downloading, print the document using a PDF reader (e.g. Adobe Reader).
Show annotations
View images
View plain text
INSTALLING PANELS <br /> Min. 1/4"gap • Panels install left to right. <br /> • • • Install the first panel locking it down onto the <br /> starter strip and keeping the left end of the panel ' <br /> 3/8" away from the furring strip. <br /> - lir"Siggillillii-11 .11.1.111111.11111111 <br /> • Fasten the panels by placing fasteners in the <br /> nailing flange; one in the center of the panel and <br /> 141 <br /> two on either side, evenly placed. Keep fasteners <br /> approximately 2" in from both ends. (Fig. 6). <br /> II3/8" Gap <br /> Min. '/:" coverage ` Fig 5 1 5 fasteners per full panel <br /> INSIDE CORNER POSTS <br /> Inside corner posts are the only finish "trim" piece to <br /> 6 <br /> be installed prior to the Fig. -4(siding panels. i J <br /> • Install any inside • Install the remainder of the course overlapping <br /> corners. Fasten thethe seams and leaving the necessary space <br /> r <br /> inside corners using between the shakes. If the temperature is above <br /> weather resistant 70°F leave 1/8", if the temperature is below 70°F <br /> screws placed inside Install inside corners leave 1/4" (Fig. 8) <br /> the pocket of the prior to siding <br /> corner no more than 1/8" Gap above 70°F <br /> 16" apart. Unlike the . 1/4" Gap Below 70°F <br /> other finished trim, <br /> inside corners are applied beforeth 'I, <br /> siding. <br /> NOTE: Make sure not to <br /> draw the pocket in when fastening to the wall. <br /> The pocket width must remain 3/4". Use a scrap <br /> piece of siding as a spacer in the pocket. The y_ ._— <br /> inside of the corner post should not lay against the I �' <br /> siding. 1 I - ?--Fig.. 10 <br /> 40 41 <br />
The URL can be used to link to this page
Your browser does not support the video tag.