Ben and Carrie Modlin vs. Historic Preservation Commission (COA#2019-1007A)

Home Browse Search

REPLACING A DAMAGED PANEL • Install Celect panel Using a circular saw, set the depth of the blade deep replacement clips by enough to cut just through the face of the damaged panel inserting the locking .:3 , but not through the wall sheathing. tab end of the clip into W `} • cut a 1" strip along the length of the panel just under the the gravity lock on the .' panel above. (Fig. 1) panel above the one IMPORTANT: Stop approximately 1" from both ends at the you removed. Nail the seams. clip to the wall. Place _.1. clips at a minimum of e 1" Cut Lines 16" apart. This will ----)0................._........, 11---....--__ secure the bottom of Fig. 3 the panel. (Fig. 3) Ag. 1 . • Locate a new panel that is as close to the length of .. the damaged panel as possible. You may have to adjust the adjacent panel(s) i. slightly to achieve a necessary Cut Line measurement. T • Remove the nailing hem of the replacement panel using a utility knife cutting along • Finish the cuts at the the indentation just below i Fig 4 seams using a utility *W : the nailing slots. knife being careful not to cut into or damage . �. ; the adjacent panel(s). �� t;: • If the panel will be On a right end seam, you will seamed on the right need to use a flat blade end, measure up from a screw driver or narrow chiselthe bottom of the ;4 to finish the cuts behind the Fig. 2 panel 2" along the seam. (Fig 2) seam locking tab. File 1 down the locking tab • Remove both the 1" strip and the remaining bottom flush with the rest of section of the panel. the tab with a knife. • Next remove the top portion or nailing hem portion of This will allow for the damaged panel. To achieve this, You'll need to easier installation at cut the fasteners holding the piece. An oscillating this seam. tool, reciprocating saw or a hack saw blade can be used. 52 53