Laserfiche WebLink
TRIM INSTALLATION <br /> • Install trim over furring strips (Fig. 10-11). It is <br /> FINAL PANEL INSTALLATION easiest to assemble window and door trims <br /> • Measure for the last panel by measuring from before applying them to the wall. When using <br /> above the nailing hem of the next to last panel to Celect trim, be sure to build the trim slightly <br /> the chalk line and add 1-1/2". larger (1/8" each side) than the window or door <br /> • Measure from the batten strip side of the last to give the finished frame room to expand and <br /> panel and cut. contract through temperature changes. <br /> • Prior to installing the panel, pre-drill a hole within • Cortex. or Pro Plug®screws and matching plugs <br /> 12" of the bottom of the panel to hold it in place. should be used when installing Celect trim. <br /> the hole should be slightly larger than the shaft Space the fasteners no more than 16" apart <br /> of the fastener. and no closer than 2" from the end of the trim. <br /> • Install the panel and place a fastener through the Make sure not to fasten through the siding or <br /> pre-drilled hole. into the expansion pocket (Fig 11). <br /> • Continue to secure the panel by placing fasteners Note:See trim assembly section for more. <br /> along the cut edge of the panel at 8"-12" <br /> intervals. The fastener head will hold the panel (- 1 <br /> back. do not fasten tightly and do NOT place the <br /> fasteners through the panel (Fig. 9). ; o ° ` : <br /> III Aft <br /> ii 1 ' SET SCREW SET PLUG <br /> ° <br /> cortex Hidden Fastening System <br /> i--- • <br /> --'71\i, <br /> .Fig. 10 <br /> fit <br /> � i <br /> 1 it 1 i I <br /> Fig. 9 .v �� / Nr <br /> Fig. 1 • <br /> 36 37 <br />