Laserfiche WebLink
EXPANSION GAP <br /> • Install the Celect siding panels keeping the ends of <br /> Min. '/4"gap the panels 1" away from the furring strips if the <br /> • • course is over 12' long, 1/2" away if the course is <br /> • less than 12' long. <br /> • Fasten the panels by placing a fastener in the center <br /> of the slot approximately every 16" leaving about <br /> 1/32" between the head of the fastener and the <br /> nailing hem of the panel. Celect panels expand and <br /> • contract through temperature changes. (Fig. 7). <br /> • If the course is longer than 12' pin the center of the <br /> iiir,,. course (not each panel) by placing a fastener in <br /> each side of one slot keeping in mind that the <br /> N. <br /> Min. 1/2" coverage "center" of each course will change as you work <br /> Fig. 5) around windows, doors, etc. (Fig. 8). <br /> INSIDE CORNER POSTS 1/2" gap if course is shorter than 12' <br /> a and no center pin of course <br /> • Install any inside corners. Fasten the inside corners necessary. <br /> in <br /> using weather resistant screws placed inside the cm <br /> pocket of the corner no more than 16" apart (Fig 6). c <br /> Unlike the other �— <br /> u_ <br /> finished trim, inside ( 1 <br /> corners are applied i1i 1" gap if course is longer than 12' <br /> before th siding. ��, and center pin the course. <br /> NOTE: Make sure not r �, Fig <br /> to draw the pocket in <br /> when fastening to � <br /> the wall. Install inside corners Center pin or box nail <br /> rior to sidin center of each course over <br /> The pocket width P g 12' i <br /> must remain 3/a". NOT each panel <br /> Use a scrap piece of ,� I__L— <br /> siding as a spacer in v' U .j.__ ._ <br /> the pocket. The 4,7 '+ <br /> inside of the corner Fig 6 <br /> post should not lay -- - <br /> against the siding. <br /> ,.v <br /> -} <br /> Fig.8 2 <br /> 20 21 <br />