Laserfiche WebLink
TRIM BOARD/FASCIA JOINTS Celect Finish Trim <br />When joining boards in areas such as under eves or <br />Horizontal <br />on fascia, a shiplap joint is recommended with the Celect Finish Trim can be <br />exception of at corners; a mitered corner will give the used to cover the cut siding <br />best appearance. edges of panels along <br />horizontal cuts or whereMiters <br />expansion and contraction Finish <br />When mitering a corner, the Glue Joint <br />following rules apply: <br />of the panel(s) is not a Trim <br />The trim board with a mitered concern. Leave /4 gap <br />2°\ between the edge of theendshouldbenolongerthen <br />panel and the trim Secure <br />Alwaysglue the ends of the <br />the finish trim with Cortex 13/4" <br />ny <br />or Pro Plu screws and <br />Init.=P <br />1 <br />1 <br />boards with PVC cement. g <br />Place a fastener 2" from the ' matching plugs <br />seam on both sides. approximately every 12"- o--1"— <br />16". <br />Managing expansion/contraction on longer runs <br />Less then 12' glued both ends <br />I <br />i--- <br />4, <br />r <br />1„ <br />Glue scarf joint <br />i• Cut board short for expansion <br />Hide with adjacent board <br />Fasteners 2" from ends max. Vertical Vertical <br />ti <br />Panel Panel <br />1 Nailing <br />Pattern <br />Glue all miters <br />DO NOT glue ship lap to allow for movement <br />i <br />r <br />Place a fastener 2" from the seam on both sides. <br />ii <br />17 iHh <br />Paint 1/4,!___, <br />Above 50°F Below 50°F Xr11, <br />48 49