Laserfiche WebLink
INSTALLING PANELS <br />Min. 1/4"gap Panels install left to right. <br />Install the first panel locking it down onto the <br />starter strip and keeping the left end of the panel <br />3/8" away from the furring strip.lir"Siggillillii- <br />11 11.1.111111.11111111 <br />Fasten the panels by placing fasteners in the <br />nailing flange; one in the center of the panel and <br />141 <br />two on either side, evenly placed. Keep fasteners <br />approximately 2" in from both ends. (Fig. 6). <br />II3/8" Gap <br />Min. '/:" coverage ` Fig 5 1 5 fasteners per full panel <br />INSIDE CORNER POSTS <br />Inside corner posts are the only finish "trim" piece to <br />6 <br />be installed prior to the Fig. <br />4( <br />siding panels. i J <br />Install any inside Install the remainder of the course overlapping <br />corners. Fasten thethe seams and leaving the necessary space <br />rinsidecornersusing between the shakes. If the temperature is above <br />weather resistant 70°F leave 1/8", if the temperature is below 70°F <br />screws placed inside Install inside corners leave 1/4" (Fig. 8) <br />the pocket of the prior to siding <br />corner no more than 1/8" Gap above 70°F <br />16" apart. Unlike the 1/4" Gap Below 70°F <br />other finished trim, <br />inside corners are <br />applied beforeth I,siding. <br />NOTE: Make sure not to <br />draw the pocket in when fastening to the wall. <br />The pocket width must remain 3/4". Use a scrap <br />piece of siding as a spacer in the pocket. The y_ ._— <br />inside of the corner post should not lay against the I <br />siding. 1 I Fig.. 10 <br />40 41