Laserfiche WebLink
TRIM INSTALLATION <br />Install trim over furring strips (Fig. 10-11). It is <br />FINAL PANEL INSTALLATION <br />easiest to assemble window and door trims <br />before applying them to the wall. When using <br />Measure for the last panel by measuring from Celect trim, be sure to build the trim slightly <br />above the nailing hem of the next to last panel to larger (1/8" each side)than the window or door <br />the chalk line and add 1-1/2". to give the finished frame room to expand and <br />Measure from the batten strip side of the last contract through temperature changes. <br />panel and cut.Cortexes or Pro Plug screws and matching plugs <br />Prior to installing the panel, pre-drill a hole within should be used when installing Celect trim. <br />12" of the bottom of the panel to hold it in place. Space the fasteners no more than 16" apart <br />of the fastener. <br />the hole should be slightly larger than the shaft and no closer than 2" from the end of the trim. <br />Make sure not to fasten through the siding or <br />Install the panel and place a fastener through the into the expansion pocket (Fig 11). <br />pre-drilled hole. Note: See trim assembly section for more. <br />Continue to secure the panel by placing fasteners <br />along the cut edge of the panel at 8"-12" <br />intervals. The fastener head will hold the panel <br />back. do not fasten tightly and do NOT place the <br />fasteners through the panel (Fig. 9). x' <br />Ail <br />SU SCREW SET PLUG <br />i <br />i likt, 1 <br />iCortiddenFastening System <br />Mk <br />1i I I It.i <br />i <br />Fig. 10 <br />11 <br />ll <br />i <br />41 <br />illit. .,,, <br />61;/1111 <br />Fig. 9 ki- d( s <br />Fig. 1 <br />37 <br />36