Laserfiche WebLink
EXPANSION GAP <br />Install the Celect siding panels keeping the ends of <br />Min. 1/4"gap the panels 1" away from the furring strips if the <br />course is over 12' long, 1/2" away if the course is <br />less than 12' long. <br />r41.11111` Fasten the panels by placing a fastener in the center <br />of the slot approximately every 16" leaving about <br />1/32" between the head of the fastener and the <br />nailing hem of the panel. Celect panels expand and <br />contract through temperature changes. (Fig. 7). <br />If the course is longer than 12' pin the center of the <br />Iri <br />i course (not each panel) by placing a fastener in <br />each side of one slot keeping in mind that the <br />center" of each course will change as you work <br />Min. 1/2" coverage Fig. 5_) around windows, doors, etc. (Fig. 8). <br />112" gap if course is shorter than 12' <br />INSIDE CORNER POSTS and no center pin of course <br />Install any inside corners. Fasten the inside cornersnecessary. <br />using weather resistant screws placed inside the o, <br />pocket of the corner no more than 16" apart (Fig 6). <br />Unlike the other u_ <br />finished trim, inside 11" gap if course is longer than 12' <br />corners are applied <br />before th siding. O4.and center pin the course. <br />NOTE: Make sure not <br />N. Fig. 7 <br />to draw the pocket in <br />r <br />when fastening to Center pin or box nail - !' <br />the wall. <br />Install inside corners center of each course over <br />The pocket width <br />prior to siding 12' 1 i <br />NOT each panel <br />must remain 3/4" <br />Use a scrap piece of N r <br />siding as a spacer in <br />the pocket. The v <br />inside of the corner Fig 6 <br />post should not lay <br />against the siding. <br />ai <br />NVr Fig.8 <br />20 <br />21