Laserfiche WebLink
INSTALLING PANELS <br /> Min. '/4"gap • Panels install left to right. <br /> . • • Install the first panel locking it down onto the <br /> starter strip and keeping the left end of the panel <br /> 3/8" away from the furring strip. <br /> '� • Fasten the panels by placing fasteners in the <br /> nailing flange; one in the center of the panel and <br /> 1 two on either side, evenly placed. Keep fasteners <br /> • approximately 2" in from both ends. (Fig. 6). <br /> i 1I <br /> �p. <br /> ., 3/8" Gap <br /> Min. ' " coverage Fig 5. i 5 fasteners per full panel <br /> I 1 <br /> INSIDE CORNER POSTS <br /> Inside corner posts are the only finish "trim" piece to <br /> be installed prior to the Fig. 6 47 <br /> siding panels. -,Y/Vr J <br /> • Install any inside • Install the remainder of the course overlapping <br /> corners. Fasten the the seams and leaving the necessary space <br /> inside corners using Y between the shakes. If the temperature is above <br /> weather resistant 70°F leave 1/8", if the temperature is below 70°F <br /> screws placed inside Install inside corners leave 1/4" (Fig. 8) <br /> the pocket of the prior to siding / <br /> corner no more than - 1/8" Gap above 70°F <br /> 16" apart. Unlike the 1/4" Gap Below 70°F <br /> other finished trim, y- <br /> inside corners areY7- y <br /> applied before th ,C Fig. 5 N , <br /> siding. <br /> NOTE: Make sure not to <br /> draw the pocket in when fastening to the wall. <br /> The pocket width must remain 3/4". Use a scrap <br /> piece of siding as a spacer in the pocket. The + _ <br /> inside of the corner post should not lay against the 1 <br /> siding. . ' -L- '' Fig.. 10 - <br /> 40 41 <br />