Opening of Bids - Venues, Parks, and Arts 2020 Chemical Supply - Hartell's, LLC.

Home Browse Search

82119_book_art.gxp 1 /16/19 1:10 PM Page 7 • For each 16 fluid ounces of a liquid tank mix partner to be applied per acre, add 0.5 teaspoon to the jar. • For each 16 fluid ounces of this product to be applied per acre, add 0.5 teaspoon to the jar. • After adding all the ingredients, place a lid on the jar and tighten. Invert 10 times to mix. • Let the mixture stand for 15 minutes and evaluate the solution for uniformity and stability. Look for separation, large flakes, precipitates, gels, heavy oily film on the jar, or other signs of incompatibility. If the tank mix partners are not compatible, do not use the mixture in a spray tank. • After compatibility testing is complete, dispose of any pesticide wastes in accordance with the STORAGE AND DISPOSAL section of this label. MIXING INSTRUCTIONS: Tank Mix Instructions: It is the pesticide user's responsibility to ensure that all products are registered for the intended use. Read and follow the applicable restrictions and limitations and directions for use on all product labels involved in tank mixing. Users must follow the most restrictive directions for use and precautionary statements of each product in the tank mixture. Prior to adding this product to the spray tank, ensure that the spray tank is thoroughly clean, particularly if an herbicide with the potential to injure crops was previously used (see Cleaning Instructions). Mix this product with water to make a finished spray solution as follows: 1. Properly calibrate and clean equipment 2. Fill the spray tank half full with water. 3. Start agitation. 4. If mixing with a flowable/wettable powder tank mix partner, prepare a slurry of the proper amount of the product in a small amount of water. Add the slurry to the spray tank. 5. If hard water is a concern, add 17 Ibs per 100 gallons of spray solution of ammonium sulfate (AMS) to the spray tank. No surfactant is required when applying this product. 6. If mixing with a liquid tank mix partner, add the liquid mix partner next. 7. Complete filling the spray tank with water before adding this product, as foaming may occur. 8. Add the proper amount of this product and continue agitation. 9. If foaming occurs, use a silicone -based antifoam agent. Ensure that all spray system lines including pipes, booms, etc. have the correct concentration of spray solution by flushing out the spray system lines before starting the crop application. Maintain good agitation at all times until contents of the tank are sprayed. If the spray mixture is allowed to settle, thorough agitation is required to re -suspend the mixture before spraying is resumed. Keep bypass line on or near bottom of tank to minimize foaming. Screen size in nozzles or line strainers must be 50 mesh or larger. 7