Laserfiche WebLink
SHALL BE <br />' lii III I „° °iii r° i by W A,Jaies AS <br />,TYPE DESCRIPTION SPECIFIED <br />(Circle One) <br />channel welded to the bottom longitudinal to form a base that will <br />rest on truck chassis. <br />Shovel Holders: Body shall include two spring mounted shovel <br />holders located on the driver's side front body bulkhead. <br />Vibrator: There shall be a vibrator mounted to the underside of <br />the dump body. Vibrator should include mounting plate and safety <br />chain. <br />Reflective Tape: There shall be a 2" reflective tape installed both <br />bottom sides and at the rear of the dump body. Tailgate shall have <br />2" reflective tape installed around the perimeter facing to the rear. <br />Spread Apron shall be three pieces with the center removable and <br />shall bolt on. Apron shall be hinged so that when pulling out of <br />spreader it will slide upwards. Spreader apron shall extend 12" <br />and shall be constructed of 7 gauge 201 94stainless steel. <br />Tailgate: The tailgate shall be constructed of 7 gauge 201 #4 stainless steel 00, YFS� NO <br />with a boxed perimeter. The tailgate shall be double acting and�,mm, <br />have two vertical and one horizontal brace to form a six -panel <br />design. The tailgate shall have 1-1/4" hardened pins. <br />The tailgate latches shall be thick, with each latch being <br />adjustable. <br />The tailgate shall be air release type. There shall be 2 air cylinders <br />for the tailgate release, and they shall be located one in each side of <br />the body rear post with an access panel. <br />Floor: The floor shall be made of 201 7-gauge stainless steel. YES NO <br />Note: In order to assure City's leaf box will fit, there shall not be <br />over a 2" radius between sides and floor of dump body. It shall be <br />bidder's obligation to insure existing leaf boxes will fit quoted <br />body. <br />Ww vawv <br />Discharge Twin augers shall convey material to rear of body. The unit shall Y / NO <br />System: have a 1/4" 201 stainless steel replaceable trough with two V-shaped 'M' rc°°°�00 <br />troughs for the two augers. <br />There shall be two step -flighted augers, one RH helical and one LH <br />helical. Augers shall be 7" OD X 4" ID with '/2" flighting on a <br />Schedule 80 pipe. The flighting shall be thick, hard surfaced to <br />12 <br />