Opening of Bids - Spec P - One or More 2019 or Newer Truck Mounted Street Sweeper - Hoosier Equipment LLC

Home Browse Search

gauges mounted in rear engine compartment. Engine and front of the engine radiator shall be accessible without the use of any tools. Engine, radiator and auxiliary engine driven devices shall be protected from the elements and vandals by twin fiberglass latching clamshell doors, opening 180 degrees, providing 270 degrees of complete accessibility to all engine maintenance components. Engine compartment to include RH mounted lockable stainless steel toolbox; 24 inches long x 13.5 inches wide x 6 3/8 inches tall for operator designated tools. Electrical Sweeper electrical system shall be independent from the chassis Systems: electrical system. Sweeper shall have an electronic back-up alarm for additional warning and safety when chassis is in reverse. For safety and to avoid damage to the main broom, side broom and elevator, all sweeping components shall automatically raise when transmission is put into reverse. Sweeper shall have a rear facing back-up camera for additional safety and operator awareness of surroundings. Sweeper lighting shall include rear identification lights, side broom and main broom spot lights and rear clearance lights. Sweeper wiring harness shall be color - coded and hot stamped with appropriate word designation labeled every four inches, i.e. "Ignition", "Side Broom" on each wire. Sweeper engine shall have one (1) 1000 CCA, 12 volt battery. Sweeper engine shall have a 60 amp. alternator. Electrical circuits to be protected by automotive style fuses. In -Cab Sweeping All sweeper controls shall be mounted on a central console Controls: located between the left and right operators position. All switches to be tactile rocker type. Control panel to be lit for night operation. One-piece, permanent control console overlay with clearly labeled switches and indicators. Sweeping mode engaged by one Sweep/Transport/Dump switch. Individual switches for left and right broom (On/Off). Individual switch for main broom and conveyor (Forward/Reverse). Individual switches for water pump on/off, right side broom water on/off and left side broom water on/off. Individual switch for throttle increase and decrease. Dust control water flow to be independently and continuously variable from off to full on for each side broom and the main broom. Hopper raise/lower and tilt to be controlled via joystick and configured per SAE standards for bucket loading equipment. Squeegee Conveyer shall be able to load hopper to 100% of rated useable Conveyer: capacity. Conveyer rotation, forward or reverse shall be selectable without leaving the cab. Conveyor shall be constructed of 11 rubber edged flights driven by steel roller type chain on polyurethane sprockets. The floor plate shall be a bolt in 11 Yes No❑ Yes NN00 Yeso No❑